FORD'S SCORPIO

1985-1994 of launch

Repair and operation of the car

Ford Skorpio
+1.1. Identification of the car
+ 2. Maintenance
- 3. Motors
   +3.1. Motor of OHC
   +3.2. Motor of DOHC
   +3.3. Motor of V6
   +3.4. Systems of ignition and management of motor
   -3.5. Diesel engines
      3.5.1. Technical characteristic
      3.5.2. The repair that does not demand the removal of the motor
      3.5.3. Check and adjust of valves slits
      +3.5.4. Fuel system
      +3.5.5. Head of the cylinder block
      3.5.6. Removal and installation of the motor
      -3.5.7. Desmontagem, repair and meeting of the motor
         3.5.7.1. Desmontagem
         -3.5.7.2. Meeting of the motor
            3.5.7.2.1. Installation of the back radical load
            3.5.7.2.2. Installation of selantes from side
            3.5.7.2.3. Meeting of stick of piston of knot
            3.5.7.2.4. Selection of pistons of diameter of the cylinder
            3.5.7.2.5. Meeting of the walk of system of distribution of gas
            3.5.7.2.6. New actions of meeting of the motor
      3.5.8. Turbocompressor
      +3.5.9. Lubrication system
      +3.5.10. System cooling
      3.5.11. Bad functioning standard of the motor
+4. System cooling
+5. Fuel system
+6. Union
+7. Transmissions
+8. Driving axle and rear bridge
+9. Direction
+10. Supports of the triangular form of interruption
+11. Brakes system
+12. Wheels and tires
+13. Body
+14. Electric equipment

3.5.7.2.6. New actions of meeting of the motor

ORDER OF REALIZATION

1. To establish a pulley of an end of inclination.

2. To remove aspects of oil or lubricant in a pin of the fixation of a pulley of an end of inclination, a lavador and of the surface of the connection of a pulley and a lavador.

3. To apply 3 decreases of Frenetanch they stick in a woodcarving in an opening of an end of inclination.

4. To hold tight a pin of the fixation of a pulley of an end of inclination the corresponding moment.

5. To establish a head of the cylinder block of the motor (3.5.5.2 to see the subsection).

6. To establish the union (6.2.3 to see the subsection).

7. To install the bomb of fuel and to adjust the moment of injection.

8. To establish:
     – a covering of a head of the cylinder block together with the new placing (to glue the placing to a covering, to hold tight nuts the moment of 3 nanômetros);
     – the thermostat of the regulator of the increased speed of the cold motor together with the new copper placing and to hold tight his moment 22,5 nanômetros;
     – incandesce captures, his tire of wire and currently electrically; to pinch you veil the moment of 50 nanômetros;
     – oil pipeline of supply of fuel;
     – the creator together with the bearer of the device of tension;
     – the bearer of a filter of oil together with new placing;
     – the oil pipeline of provision of oil to an axle of levers of valves.

9. To annex a tube of leak advanced to a final collector.

10. To install devices of tension of belts of side, the auxiliary bomb of the system of the direction, the bomb of vacuum and the ventilator of an electric heater.

11. To put and to pull belts of side.

12. To measure a slit of the walk of the bomb of oil.