FORD'S SCORPIO

1985-1994 of launch

Repair and operation of the car


Ford Skorpio
+1.1. Identification of the car
+ 2. Maintenance
- 3. Motors
   +3.1. Motor of OHC
   +3.2. Motor of DOHC
   +3.3. Motor of V6
   +3.4. Systems of ignition and management of motor
   -3.5. Diesel engines
      3.5.1. Technical characteristic
      3.5.2. The repair that does not demand the removal of the motor
      3.5.3. Check and adjust of valves slits
      +3.5.4. Fuel system
      +3.5.5. Head of the cylinder block
      3.5.6. Removal and installation of the motor
      +3.5.7. Desmontagem, repair and meeting of the motor
      3.5.8. Turbocompressor
      +3.5.9. Lubrication system
      +3.5.10. System cooling
      3.5.11. Bad functioning standard of the motor
+4. System cooling
+5. Fuel system
+6. Union
+7. Transmissions
+8. Driving axle and rear bridge
+9. Direction
+10. Supports of the triangular form of interruption
+11. Brakes system
+12. Wheels and tires
+13. Body
+14. Electric equipment


bfe6b27a


3.5.8. Turbocompressor
GENERAL INFORMATION

Turbocompressor

The oil pipeline of provision of oil to a turbocompressor

Removal

ORDER OF REALIZATION
1. To withdraw a negative wire of the accumulator.
2. To withdraw the protection of a case and a fender.
3. To unscrew nuts and desconectar a reception they exhaust the tube of a turbocompressor.
4. Desconectar a tube of repayable oil of a turbocompressor.
5. To withdraw an air they supply to the tube of branch of a turbocompressor.
6. There withdraws a tube of branch the collector who joins and a turbocompressor.
7. To withdraw the oil pipeline of the provision of oil to a turbocompressor.
8. To unscrew four pins of the fixation of a turbocompressor to a final collector and a driving compartment withdraws his turbocompressor lowland down.
9. To compensate carefully for the inter-connected surfaces in a collector and a turbocompressor.

Installation

The installation is done in the sequence, the return to the removal. At the same time it is necessary to pay attention to some characteristics:

   – it is compulsory to establish the new placing;
   – after the installation of a turbocompressor to withdraw the capture of food of the valve eletromagnética in the bomb of fuel of the high pressure. There turns the motor an author until the bulb of control of the pressure of oil does not go out. It is necessary so that the oil brought near to loads turbocompressor, otherwise they can fail.

Launch of the motor after capital repairs
ORDER OF REALIZATION
1. After the installation of the motor in the car to check the level of oil and liquid that cools.
2. To withdraw the capture of the valve eletromagnética of a stop of the motor and there turns the motor an author until the lamp of the pressure of emergence of oil goes out. The capture adheres to the valve eletromagnética of a stop of the motor.
3. To begin the motor and to check the tension of all the systems. The smoking of the motor is the normal phenomenon how there is an ardency out of the oil of the motor that climbed a detail in the meeting.