|
BAD FUNCTIONING
|
REASON
|
| The motor is not begun: |
| – the author revolves slowly | The accumulator is not accused completely.
Oxidation of captures of the accumulator.
Hardly contact between a body, the motor and the negative capture of the accumulator. |
| – the author revolves normally, but the motor is not begun | The union obgonny belongs defective to an author.
Teeths of a garland of gear of a pendulum is used. |
| The complicated launch of the motor | Insufficient fuel provision.
Low compression in motor cylinders.
The bomb of fuel of the high pressure is defective. |
| The flashes of lightning separated in cylinders are observed, but the motor is not begun | Insufficient fuel provision.
The suction of additional air in a power supplies to the system. |
| The motor stopped and one does not begin | The fuel addresses completely.
The fuel filter is polluted.
The motor is overheated. |
| Motor constantly overheats | It is lacking of cooling the liquid.
The thermostat is defective.
The amount of oil is not enough.
Brakes interference.
Passability of an electric heater is reduced.
Passability of tubes of branch of the system of cooling is reduced.
Prohibit to cool the motor overheated with the cold water as it can lead to the slits formation and cause the deformation of separate unities of the motor. |
| Existence of strange noises in the motor: |
| – I whistle or whistle of air | The tension of a hose of vacuum of the amplifier of brakes is broken.
Burn - out of placing of a collector.
Burn - out of placing of a head of the cylinder block.
Sliding of driving of belts of side in pulleys.
I use the load of the creator or water bomb. |
| – blow touch | The valves slits are not adjusted.
First injection of fuel in cylinders.
Defect in rings of piston or fingers. |
| – deaf blow | The radical necks or conrod of an inclination end they are used. |
| The increased smoke of the motor | The black smoke appears in the moment of a contamination of the filter of air or the incomplete close of a needle of a mouth.
The white smoke appears in incomplete combustion of the fuel, delay of the injection of the fuel or a defective mouth.
The gray smoke appears in the use of group of tsilindro-piston of motor or bad functioning of the system of fuel. |
