FORD'S SCORPIO

1985-1994 of launch

Repair and operation of the car

Ford Skorpio
+1.1. Identification of the car
+ 2. Maintenance
- 3. Motors
   +3.1. Motor of OHC
   +3.2. Motor of DOHC
   +3.3. Motor of V6
   +3.4. Systems of ignition and management of motor
   -3.5. Diesel engines
      3.5.1. Technical characteristic
      3.5.2. The repair that does not demand the removal of the motor
      3.5.3. Check and adjust of valves slits
      +3.5.4. Fuel system
      +3.5.5. Head of the cylinder block
      3.5.6. Removal and installation of the motor
      -3.5.7. Desmontagem, repair and meeting of the motor
         3.5.7.1. Desmontagem
         -3.5.7.2. Meeting of the motor
            3.5.7.2.1. Installation of the back radical load
            3.5.7.2.2. Installation of selantes from side
            3.5.7.2.3. Meeting of stick of piston of knot
            3.5.7.2.4. Selection of pistons of diameter of the cylinder
            3.5.7.2.5. Meeting of the walk of system of distribution of gas
            3.5.7.2.6. New actions of meeting of the motor
      3.5.8. Turbocompressor
      +3.5.9. Lubrication system
      +3.5.10. System cooling
      3.5.11. Bad functioning standard of the motor
+4. System cooling
+5. Fuel system
+6. Union
+7. Transmissions
+8. Driving axle and rear bridge
+9. Direction
+10. Supports of the triangular form of interruption
+11. Brakes system
+12. Wheels and tires
+13. Body
+14. Electric equipment

3.5.7.2.1. Installation of the back radical load

GENERAL INFORMATION

Numeration of coverings of radical loads

ORDER OF REALIZATION

1. Radical load installs the placing in a flute in the cylinder block and a covering of the back.

2. To establish a nucleus of the special adaptation (21.085) in the placing.

3. To beat with the wooden hammer the flat surface of the special adaptation for which the placing as appropriate the flute was filling provided it and was not exposed to the deformation. The ends of the placing are level with the airplane of the cylinder block and coverings; this airplane that puts material elements it must not influence.

4. To insertions of motor of oil with oil flutes and it to put them in nests of the cylinder block, installment of attention that were in the same nests in which it was before (to observe the fulfilled designations).

5. To establish carefully an end of inclination in insertions of radical loads.

6. 2, 3,4 and 5 establishes coverings of radical loads n °, and also previously, without selantes from side, covering n ° 1 of load.

7. To hold tight pins of coverings of radical loads the moment of 110 nanômetros.

8. To arrange indicative of hour they type so that his tip of measuring concerned an advanced part of an end of inclination.

9. To check an axial slit of an end of inclination that will do 0,08-0,29 mm.

10. In case of the unsuitable value of an axial slit it is necessary to substitute the persistent half of the rings of the end of inclination; for the choice there is two thickness: 2,30 and 2,50 mm.