FORD'S SCORPIO

1985-1994 of launch

Repair and operation of the car



Ford Skorpio
+1.1. Identification of the car
+ 2. Maintenance
- 3. Motors
   +3.1. Motor of OHC
   +3.2. Motor of DOHC
   +3.3. Motor of V6
   +3.4. Systems of ignition and management of motor
   -3.5. Diesel engines
      3.5.1. Technical characteristic
      3.5.2. The repair that does not demand the removal of the motor
      3.5.3. Check and adjust of valves slits
      +3.5.4. Fuel system
      +3.5.5. Head of the cylinder block
      3.5.6. Removal and installation of the motor
      -3.5.7. Desmontagem, repair and meeting of the motor
         3.5.7.1. Desmontagem
         -3.5.7.2. Meeting of the motor
            3.5.7.2.1. Installation of the back radical load
            3.5.7.2.2. Installation of selantes from side
            3.5.7.2.3. Meeting of stick of piston of knot
            3.5.7.2.4. Selection of pistons of diameter of the cylinder
            3.5.7.2.5. Meeting of the walk of system of distribution of gas
            3.5.7.2.6. New actions of meeting of the motor
      3.5.8. Turbocompressor
      +3.5.9. Lubrication system
      +3.5.10. System cooling
      3.5.11. Bad functioning standard of the motor
+4. System cooling
+5. Fuel system
+6. Union
+7. Transmissions
+8. Driving axle and rear bridge
+9. Direction
+10. Supports of the triangular form of interruption
+11. Brakes system
+12. Wheels and tires
+13. Body
+14. Electric equipment


bfe6b27a


3.5.7.2.5. Meeting of the walk of system of distribution of gas

GENERAL INFORMATION

System of distribution of gas

1 - covering of a chain of driving of system of distribution of gas,
2 - placing of a covering,
3 - intermediary plate,
4 - placing of a plate,
5 - axle asterisk,
6 - chain of system of distribution of gas,
7 - asterisk of the device of tension of a chain,
8 - load gives ball,
9 - clown,
10 - taken,
11 - small child,
12 - axle of levers of valves,
13 - bearer of an axle of levers of valves,
14 - valve lever,
15 - bearer of blockade of an axle of levers of valves,
16 - spring agreement of an axle of levers of valves,
17 - lavadores flat,
18 - empurrador,
19 - nucleus of empurrador,
20 - final valve,
21 - entry valve,
22 - fine cookies of fixation of a basic spring plate of the valve,
23 - superior basic valve spring plate,
24 - spring of valve,
25 - lower the basic spring plate of valve,
26 - selante of valve nucleus

Mechanism of Krivoshipno-shatunny

1 - inclination end,
2 - pulley,
3 - asterisk,
4 - ring fighter,
5 - the capture that allies of a main end of the transmission,
6 - pendulum,
7 - lavador of fixation of pins of fixation of a pendulum,
8 - insertions of radical loads,
9 - persistent half of rings of an end of inclination,
10 - selante of the back radical load,
11 - stick pin,
12 - it pierces,
13 - taken of head of stick,
14 - insertion of the load of conrod,
15 - piston,
16 - piston finger,
17 - ring of scraper of oil,
18 - lower ring fighter,
19 - ring of superior fighter (compression)

During the correct installation of an asterisk in an inclination end the sign (1) will be visible



To adjust signs of asterisks and to direct chain of system of distribution of gas



Tension of a chain of driving of system of distribution of gas


Removal of the device of tension of a chain of driving of system of distribution of gas



ORDER OF REALIZATION
1. To establish (with an agreement they sign the party on the outside) a chain asterisk together with a spline in an inclination end.
2. To establish a flange of the bearer of an asterisk of the walk of the fuel they pump together with the oil pipeline of oil producing resources.
3. To install the device of tension of a chain of driving of the system of the distribution of gas.
4. To establish an asterisk of the walk of the bomb of fuel and to become an end of inclination so that the piston in the 1st cylinder was in VMT.
5. To establish a chain of driving of the system of the distribution of gas so that his designations of the red color coincided with alista asterisks of an axle and the bomb of fuel, and the designation of the white color – with alista an asterisk of an end of inclination.
6. To establish an asterisk of the device of tension of a chain together with the clown and to pull a chain so that it receives a 0.5-1 mm slit between a face of the device of tension and his bearer. To hold tight a roll of the device of tension.
7. To substitute a ring of fighter of a covering of a chain of driving of the system of the distribution of gas and to screw a covering.