Ford Skorpio
+1.1. Identification of the car
+ 2. Maintenance
- 3. Motors
+3.1. Motor of OHC
+3.2. Motor of DOHC
+3.3. Motor of V6
+3.4. Systems of ignition and management of motor
-3.5. Diesel engines
3.5.1. Technical characteristic
3.5.2. The repair that does not demand the removal of the motor
3.5.3. Check and adjust of valves slits
-3.5.4. Fuel system
3.5.4.1. Mouths
3.5.4.2. Taken of incandescence
3.5.4.3. Check of a compression
3.5.4.4. Removal of air of system of fuel
3.5.4.5. Removal and installation of the bomb of fuel
3.5.4.6. Check and adjust of turns of wasting time
3.5.4.7. Increase thread in turns of wasting time
+3.5.5. Head of the cylinder block
3.5.6. Removal and installation of the motor
+3.5.7. Desmontagem, repair and meeting of the motor
3.5.8. Turbocompressor
+3.5.9. Lubrication system
+3.5.10. System cooling
3.5.11. Bad functioning standard of the motor
+4. System cooling
+5. Fuel system
+6. Union
+7. Transmissions
+8. Driving axle and rear bridge
+9. Direction
+10. Supports of the triangular form of interruption
+11. Brakes system
+12. Wheels and tires
+13. Body
+14. Electric equipment
|
Taken of incandescence with the burned tip
| ORDER OF REALIZATION |
| For the check of candles of an incandescence for desconectar the tire of food of candles. A capture joins a lamp of control (any bulb in the voltage of 12 V) to a positive pole of the accumulator and other to the checked candle established in the motor. If the bulb is burned – the candle is useful. If the bulb is not burned - the candle is defective and is subject to the substitution. |
|
Obgoraniye and the failure of a capture of incandescence very often are a consequence of the bad functioning of mouths. If there is a burned candle, then simple substitution insuficientemente. It is necessary to execute the inspection of mouths including the definition of the form of a torch of the dispersal, the pressure of operation and tension. It is important that the mouth had a right short cut of the fuel. |
|
