Ford Skorpio
+1.1. Identification of the car
+ 2. Maintenance
- 3. Motors
+3.1. Motor of OHC
-3.2. Motor of DOHC
3.2.1. Technical characteristic
+3.2.2. The repair that does not demand the removal of the motor
-3.2.3. Removal and installation of the motor without transmission
3.2.3.1. Removal of the motor
3.2.3.2. Additional operations in removal of the motor in cars with AKP
3.2.3.3. Additional operations in removal of the motor with the transmission
3.2.3.4. Installation of the motor
3.2.3.5. Desmontagem of the motor
3.2.3.6. Cylinders
3.2.3.7. Check and restoration of pistons and rings of piston
3.2.3.8. Fingers of piston and sticks
3.2.3.9. Inclination end
3.2.3.10. Radical loads and conrod
3.2.3.11. Pendulum
3.2.3.12. Meeting of the motor
3.2.3.13. Launch of the motor after capital repairs
3.2.4. System of ventilation of a case
+3.2.5. Lubrication system
+3.3. Motor of V6
+3.4. Systems of ignition and management of motor
+3.5. Diesel engines
+4. System cooling
+5. Fuel system
+6. Union
+7. Transmissions
+8. Driving axle and rear bridge
+9. Direction
+10. Supports of the triangular form of interruption
+11. Brakes system
+12. Wheels and tires
+13. Body
+14. Electric equipment
|
The installation of the motor is done in the sequence, the return to the removal, at the same time it is necessary to pay attention to some characteristics:
– lubrication for oil of shlits of an end of union of the transmission before connection of these knots;
– during the installation of the union in a pendulum there is necessary the alignment centers a plate of pressure mandrel;
– if in the connection of the transmission to the motor, the main end of the transmission not to enter in a pressure plate is necessary to become an end of inclination of the motor a little;
– to establish the new placing of a tube of advanced leak;
– to fill the system of cooling of the corresponding liquid and to withdraw the air of the system of cooling;
– to check and in case of the necessity of advanced corner to adjust an ignition, and also motor speed to waste time and concentration with in leak gases. |
|
