FORD'S SCORPIO

1985-1994 of launch

Repair and operation of the car

Ford Skorpio
+1.1. Identification of the car
+ 2. Maintenance
- 3. Motors
   +3.1. Motor of OHC
   -3.2. Motor of DOHC
      3.2.1. Technical characteristic
      +3.2.2. The repair that does not demand the removal of the motor
      -3.2.3. Removal and installation of the motor without transmission
         3.2.3.1. Removal of the motor
         3.2.3.2. Additional operations in removal of the motor in cars with AKP
         3.2.3.3. Additional operations in removal of the motor with the transmission
         3.2.3.4. Installation of the motor
         3.2.3.5. Desmontagem of the motor
         3.2.3.6. Cylinders
         3.2.3.7. Check and restoration of pistons and rings of piston
         3.2.3.8. Fingers of piston and sticks
         3.2.3.9. Inclination end
         3.2.3.10. Radical loads and conrod
         3.2.3.11. Pendulum
         3.2.3.12. Meeting of the motor
         3.2.3.13. Launch of the motor after capital repairs
      3.2.4. System of ventilation of a case
      +3.2.5. Lubrication system
   +3.3. Motor of V6
   +3.4. Systems of ignition and management of motor
   +3.5. Diesel engines
+4. System cooling
+5. Fuel system
+6. Union
+7. Transmissions
+8. Driving axle and rear bridge
+9. Direction
+10. Supports of the triangular form of interruption
+11. Brakes system
+12. Wheels and tires
+13. Body
+14. Electric equipment

3.2.3.3. Additional operations in removal of the motor with the transmission

ORDER OF REALIZATION

1. For desconectar a reception they exhaust the tube of the system of leak and to withdraw it of the car.

2. In cars with the catalyst to withdraw the fabric that protects the heat.

3. To withdraw the driving axle.

4. To support the transmission through the corresponding elevator and a wide plank and to lift a little the transmission.

5. To unscrew four nuts of the fixation of a ray of a box to the bottom of the car and the central pin of the fixation of a ray to the transmission. To withdraw a ray.

6. To lower a little the transmission and desconectar a speedometer they direct the thread.

7. Desconectar a wire of the switch of lamps of a support.

8. In cars with the system of the injection of the fuel for desconectar wires of the sensor of the speed of the car that locates side transmissions.

9. To unscrew two pins of the fixation of the support of the triangular form of support of the contact of the coulisse for the transmission.

10. The corresponding punch to beat a finger of the fixation of a bar of the choice of transfers for the transmission.

11. To establish таль to stand up of the motor and to lift the motor. The length to slingshot and his agreement they will be such what lifting the unity of power lifted in an angle 40-45 °.

12. To unscrew supports of the triangular form of the fixation of the motor of the cylinder block.

13. To check what the steering-wheel establishes in the provision of the movement straightly ahead and painting or a marker to observe the provision of the lowest collar of an intermediary end and wheel of gear of directing the transfer, soon desconectar an intermediary end of directing the transfer.

14. Desconectar tubes of brake of an advanced part of a ray of a support of the triangular form of interruption.

15. To support a ray through the corresponding elevator and a wide plank (without withdrawing a monkey of bass of the transmission), unscrewing pins of the fixation of a ray to the bottom of the car and withdrawing it.

16. To check that all the hoses and the wires if desconectam of the motor and the transmission and to lower the monkey that supports the transmission.

17. To lower motor together with the transmission I lower and to take of bass of the car.