FORD'S SCORPIO

1985-1994 of launch

Repair and operation of the car



Ford Skorpio
+1.1. Identification of the car
+ 2. Maintenance
- 3. Motors
   +3.1. Motor of OHC
   -3.2. Motor of DOHC
      3.2.1. Technical characteristic
      +3.2.2. The repair that does not demand the removal of the motor
      -3.2.3. Removal and installation of the motor without transmission
         3.2.3.1. Removal of the motor
         3.2.3.2. Additional operations in removal of the motor in cars with AKP
         3.2.3.3. Additional operations in removal of the motor with the transmission
         3.2.3.4. Installation of the motor
         3.2.3.5. Desmontagem of the motor
         3.2.3.6. Cylinders
         3.2.3.7. Check and restoration of pistons and rings of piston
         3.2.3.8. Fingers of piston and sticks
         3.2.3.9. Inclination end
         3.2.3.10. Radical loads and conrod
         3.2.3.11. Pendulum
         3.2.3.12. Meeting of the motor
         3.2.3.13. Launch of the motor after capital repairs
      3.2.4. System of ventilation of a case
      +3.2.5. Lubrication system
   +3.3. Motor of V6
   +3.4. Systems of ignition and management of motor
   +3.5. Diesel engines
+4. System cooling
+5. Fuel system
+6. Union
+7. Transmissions
+8. Driving axle and rear bridge
+9. Direction
+10. Supports of the triangular form of interruption
+11. Brakes system
+12. Wheels and tires
+13. Body
+14. Electric equipment


bfe6b27a


3.2.3. Removal and installation of the motor without transmission

3.2.3.1. Removal of the motor

GENERAL INFORMATION

The removal of the motor without transmission is done from a driving compartment through the mechanism that lifts the load. Also there is possible motor does the removal of together with the transmission, nevertheless, link much more with difficulty as for this objective that must install the car in the elevator and through the additional elevator to lower motor together with the transmission down, previously having desconectado and having withdrawn the lowland of interference of unities of the unity of power.

ORDER OF REALIZATION
1. To withdraw a negative wire of the accumulator.
Prevention

In cars with the condicionador, the elements of the system of air conditioning can complicate the realization of the work in the motor, and not always it is possible to unscrew pins and to move elements of system to the part because of the insufficient length of his hoses. In this case, the system of air conditioning has to be unloaded by the businessman of Ford or the specialist in condicionadores.


2. To withdraw the protection of a case and a fender.
3. To withdraw a front guard.
4. Desconectar a thread of the opening of a monk's hood of the mechanism of the close of a monk's hood and to take of armbands.
5. To withdraw a monk's hood, previously having observed the provision of knots, for the simplification of the repeated installation and having desconectado a tube of lavador of windshield.
6. To fuse the liquid that cools of the cooling system for what below a cork of drain of an electric heater to substitute the corresponding container and to open the cork of drain it located in the lowest part of an electric heater. For the acceleration of the unloading of cooling the liquid to open a cork of a wide tank. For the unloading of cooling the liquid of the cylinder block to unscrew the pin of drainage located in the cylinder block.
7. To supply a place of additional work to withdraw an electric heater.
8. Desconectar hoses of cooling the liquid of the case of the water bomb in the left side of the motor and a head of the block of the cylinder.
9. To weaken collars and to withdraw tubes of branch and hoses of the system of cooling:
      – top and tubes of branch more basses of an electric heater;
      – hoses of a wide tank;
      – hoses of system of heating of hall of a head of the cylinder block and the bomb of the system of cooling;
      – cases of the automatic initial agreement of the carburator.
10. To fuse the oil of motor and to withdraw the filter.
11. To unscrew four pins of the fixation of the top they dispatch the crossbeam, two pins of two parties in top and two pins lower of the fixation of a support of a crossbeam and to withdraw it together with an electric heater.
12. To withdraw the filter of air.
13. To withdraw a hose of a sapun of a covering of a head of the cylinder block and to unscrew the pin that fixes a support of the triangular form of interruption of the support of a hose to the left advanced side of a head of the block of the cylinder.
14. To withdraw the hose of fuel of supply of the bomb of fuel and to deaden it a cork.
15. Desconectar an electronic valve of the amplifier of brakes of a collector of entry.
16. Desconectar electric wires and to withdraw taken of the next unities and sensors:
      – creator;
      – author;
      – electric heater supporter;
      – Meter of REVOLUTIONS PER MINUTE and provision of an end of inclination;
      – temperature sensor;
      – sensor of temperature of a system of control of the motor;
      – sensor of pressure of oil;
      – ignition distributor;
      – ignition rolls;
      – knots of system of injection of fuel and mouths of fuel;
      – sensor of provision of a valve of butterfly;
      – sensor of temperature of fuel;
      – heater of the automatic air door;
      – electric heater thermal sensor.
17. To remove of the ignition distributor the distributor of the high voltage together with wires.
18. Desconectar a gas pedal thread.
19. Desconectar fuel and hoses of vacuum, and also electric wires of the carburator.
20. There take away the side a belt and the auxiliary bomb of the system of driving (if it is present at this version). To lift the auxiliary bomb to a hoof of the car through a gentle wire, at the same time not desconectar hoses of the bomb.
21. In the interior of the car to establish a bar below a pedal of union so that it registers it in the superior situation, for an exception of the operation of the automatic regulator of a tension of a thread of the union.
22. To withdraw a thread of union.
23. In models with the air conditioning to unscrew 4 pins of the fixation of the compressor of the condicionador (they are specified by firearms in the drawing (vision of bottom)) of a support of the triangular form of interruption of the installation and to move the compressor of the motor.
24. To check what the steering-wheel establishes in the provision of the movement straightly ahead and painting or a marker to observe the provision of the lowest collar of an intermediary end and wheel of gear of directing the transfer, soon desconectar an intermediary end of directing the transfer (the pin of the fixation is specified by an arrow).
25. To unscrew an advanced tube of reception of a final collector.
26. To unscrew collars of the fixation of the stabilizer and to withdraw the stabilizer.
27. In cars with the automatic exchange to unscrew the converter of torque of a disc of driving.
28. To establish таль to stand up of the motor and to lift the motor so that the weight of the motor realized a waist, and soon in order that bearers of the motor to unscrew.
29. To unscrew pins of the fixation of a case of the union.
30. Desconectar electric wires and to remove an author.
31. For desconectar they connect a weight of the motor.
32. To withdraw the bearer located between the motor and the transmission.
33. Desconectar tubes of the system of brakes of an advanced support of the triangular form of interruption.
34. To support the transmission through the corresponding elevator and a wide plank and to lift a little the transmission.
35. Care that has, the mechanism that lifts the load to lift the motor and to separate of him the transmission.
36. Lifting of the motor, at the same time to move it ahead and, turning it in the horizontal airplane, to take.