FORD'S SCORPIO

1985-1994 of launch

Repair and operation of the car



Ford Skorpio
+1.1. Identification of the car
+2. Maintenance
+3. Motors
+ 4. System cooling
- 5. Fuel system
   5.1. Technical characteristic
   5.2. Fuel
   5.3. Gasoline without lead of V6, 2,4 motors and 2,9 dm3
   +5.4. System of air provision
   +5.5. Carburator of PIERBURG
   +5.6. WEBER 2V carburator
   +5.7. WEBER 2V carburator of TLD
   -5.8. System of injection of fuel
      5.8.1. Turns agreement of wasting time and quality of mixture
      5.8.2. Removal and installation of the sensor of provision of a valve of butterfly
      5.8.3. Removal and installation of the valve of management of turns waste time
      5.8.4. Removal and installation of measuring instruments of a draft
      5.8.5. Removal and installation of mouths of fuel
      5.8.6. Removal and installation of the sensor of temperature of the road of fuel
      5.8.7. Removal and installation of the regulator of pressure of fuel
      5.8.8. Removal and installation of the case of a valve of butterfly in the motor DOHC
      5.8.9. Removal and installation of the sensor of oxygen (HEGO)
      5.8.10. Removal and installation from a coal adsorber
      5.8.11. Removal and installation of the valve eletromagnética of a coal adsorber
   5.9. Removal and installation of a collector of entry
+6. Union
+7. Transmissions
+8. Driving axle and rear bridge
+9. Direction
+10. Supports of the triangular form of interruption
+11. Brakes system
+12. Wheels and tires
+13. Body
+14. Electric equipment


bfe6b27a


5.8.9. Removal and installation of the sensor of oxygen (HEGO)

GENERAL INFORMATION

MODELS WITH THE CATALYST

Prevention

The sensor HEGO – the very sweet and sensitive device also can be damaged in the moment of the punch, and also in the interval of the food. A sensor tip prohibits to touch barehanded.


ORDER OF REALIZATION
1. To withdraw a weight they connect of the accumulator.
2. To lift an advanced part of the car.
3. To withdraw the capture of the sensor, previously having launched armbands.
4. To withdraw the thermal fabric of the sensor.
5. To unscrew the sensor of a tube of leak and to take a ring of fighter.
6. The installation is done in the sequence, the return to the removal, at the same time it is necessary to establish a new ring of fighter.