FORD'S SCORPIO

1985-1994 of launch

Repair and operation of the car



Ford Skorpio
+1.1. Identification of the car
+2. Maintenance
+3. Motors
+ 4. System cooling
- 5. Fuel system
   5.1. Technical characteristic
   5.2. Fuel
   5.3. Gasoline without lead of V6, 2,4 motors and 2,9 dm3
   +5.4. System of air provision
   +5.5. Carburator of PIERBURG
   +5.6. WEBER 2V carburator
   +5.7. WEBER 2V carburator of TLD
   -5.8. System of injection of fuel
      5.8.1. Turns agreement of wasting time and quality of mixture
      5.8.2. Removal and installation of the sensor of provision of a valve of butterfly
      5.8.3. Removal and installation of the valve of management of turns waste time
      5.8.4. Removal and installation of measuring instruments of a draft
      5.8.5. Removal and installation of mouths of fuel
      5.8.6. Removal and installation of the sensor of temperature of the road of fuel
      5.8.7. Removal and installation of the regulator of pressure of fuel
      5.8.8. Removal and installation of the case of a valve of butterfly in the motor DOHC
      5.8.9. Removal and installation of the sensor of oxygen (HEGO)
      5.8.10. Removal and installation from a coal adsorber
      5.8.11. Removal and installation of the valve eletromagnética of a coal adsorber
   5.9. Removal and installation of a collector of entry
+6. Union
+7. Transmissions
+8. Driving axle and rear bridge
+9. Direction
+10. Supports of the triangular form of interruption
+11. Brakes system
+12. Wheels and tires
+13. Body
+14. Electric equipment


bfe6b27a


5.8.6. Removal and installation of the sensor of temperature of the road of fuel

GENERAL INFORMATION

Installation of a clip of a conector of the road of fuel in V6, 2,4 motors and 2,9 dm3


Fuel builds a road distributive of V6, 2,4 motors and 2,9 dm3

1 - regulator of pressure of fuel,

2 - sensor of temperature of fuel,

3 - fuel road,

4 - fuel mouths

Removal of the switch of sensor of temperature of the road of fuel in V6, 2,4 motors and 2,9 dm3


ORDER OF REALIZATION
1. To withdraw a weight they connect of the accumulator.
2. Distributive road withdraws the capture of the sensor of temperature of the fuel.
3. To withdraw the sensor of the road of fuel.
4. The installation is done in the sequence of the return to the removal.