FORD'S SCORPIO

1985-1994 of launch

Repair and operation of the car


Ford Skorpio
+1.1. Identification of the car
+2. Maintenance
+3. Motors
+ 4. System cooling
- 5. Fuel system
   5.1. Technical characteristic
   5.2. Fuel
   5.3. Gasoline without lead of V6, 2,4 motors and 2,9 dm3
   +5.4. System of air provision
   +5.5. Carburator of PIERBURG
   +5.6. WEBER 2V carburator
   +5.7. WEBER 2V carburator of TLD
   -5.8. System of injection of fuel
      5.8.1. Turns agreement of wasting time and quality of mixture
      5.8.2. Removal and installation of the sensor of provision of a valve of butterfly
      5.8.3. Removal and installation of the valve of management of turns waste time
      5.8.4. Removal and installation of measuring instruments of a draft
      5.8.5. Removal and installation of mouths of fuel
      5.8.6. Removal and installation of the sensor of temperature of the road of fuel
      5.8.7. Removal and installation of the regulator of pressure of fuel
      5.8.8. Removal and installation of the case of a valve of butterfly in the motor DOHC
      5.8.9. Removal and installation of the sensor of oxygen (HEGO)
      5.8.10. Removal and installation from a coal adsorber
      5.8.11. Removal and installation of the valve eletromagnética of a coal adsorber
   5.9. Removal and installation of a collector of entry
+6. Union
+7. Transmissions
+8. Driving axle and rear bridge
+9. Direction
+10. Supports of the triangular form of interruption
+11. Brakes system
+12. Wheels and tires
+13. Body
+14. Electric equipment


bfe6b27a


5.8.11. Removal and installation of the valve eletromagnética of a coal adsorber
GENERAL INFORMATION

MODELS WITH THE CATALYST

Valve eletromagnética of a coal adsorber

The valve eletromagnética of a coal adsorber is specified by an arrow.

The valve is located in the right part of a driving compartment, near to the fixation of a torture of a support of the triangular form of interruption.

ORDER OF REALIZATION
1. To withdraw a weight they connect of the accumulator.
2. To call - of the capture of eletroímã.
3. Desconectar 2 tubes of an eletroímã, having remembered his agreement, and to withdraw it.
4. The installation is done in the sequence of the return to the removal.
5. To supply the correct installation of tubes and the direction of the valve.








QX4.ONLINE
S40.ONLINE
A-8.ONLINE
W124.ONLINE
RX300.ONLINE
W140.ONLINE
B3-B4.SPACE
B3B4.SPACE
A-8.SPACE