FORD'S SCORPIO

1985-1994 of launch

Repair and operation of the car

Ford Skorpio
+1.1. Identification of the car
+2. Maintenance
+3. Motors
+ 4. System cooling
- 5. Fuel system
   5.1. Technical characteristic
   5.2. Fuel
   5.3. Gasoline without lead of V6, 2,4 motors and 2,9 dm3
   +5.4. System of air provision
   +5.5. Carburator of PIERBURG
   +5.6. WEBER 2V carburator
   -5.7. WEBER 2V carburator of TLD
      5.7.1. Removal and installation of the carburator
      5.7.2. Turns agreement of wasting time and quality of mixture
      5.7.3. Valve of needle of the camera made work for the buoy
      5.7.4. Device of vacuum of the walk of a valve of butterfly of the secondary camera
      5.7.5. Substitution of a diaphragm of the valve of the economizador
      5.7.6. Automatic initial agreement
      5.7.7. Turns agreement of bystry to waste time
      5.7.8. Removal and installation of a damper of a valve of butterfly
      5.7.9. Adjust
   +5.8. System of injection of fuel
   5.9. Removal and installation of a collector of entry
+6. Union
+7. Transmissions
+8. Driving axle and rear bridge
+9. Direction
+10. Supports of the triangular form of interruption
+11. Brakes system
+12. Wheels and tires
+13. Body
+14. Electric equipment

5.7.8. Removal and installation of a damper of a valve of butterfly

GENERAL INFORMATION

Knot of empurrador of regulator

1 - tube of branch of fuel of entry,
2 - air door,
3 - bomb acceleration,
4 - lever of empurrador of diaphragm,
5 - plastic covering,
6 - damper of a valve of butterfly,
7 - diaphragm of vacuum of a valve of butterfly of the secondary camera

ORDER OF REALIZATION

1. To withdraw a weight they connect of the accumulator and the case of the filter of air.

2. To withdraw a hose of vacuum of a damper.

3. To withdraw the plastic fabric of a damper of a valve of butterfly.

4. To unscrew two screws of the fixation, to take the operational stick of the coulisse of a valve of butterfly and to take the meeting of the carburator.

5. To unscrew four screws of the fixation, to discover a diaphragm and to take one spring.

6. To take a diaphragm of the case.

7. To compensate for the inter-connected surfaces of the case and a covering of a diaphragm.

8. To install a diaphragm, one spring, a covering in the case and to screw screws of the fixation of a covering.

9. The new meeting is done in the sequence, the desmontagem of return, but before the installation of the plastic fabric to check the agreement of a damper of a valve of butterfly.