FORD'S SCORPIO

1985-1994 of launch

Repair and operation of the car



Ford Skorpio
+1.1. Identification of the car
+2. Maintenance
+3. Motors
+ 4. System cooling
- 5. Fuel system
   5.1. Technical characteristic
   5.2. Fuel
   5.3. Gasoline without lead of V6, 2,4 motors and 2,9 dm3
   +5.4. System of air provision
   +5.5. Carburator of PIERBURG
   +5.6. WEBER 2V carburator
   -5.7. WEBER 2V carburator of TLD
      5.7.1. Removal and installation of the carburator
      5.7.2. Turns agreement of wasting time and quality of mixture
      5.7.3. Valve of needle of the camera made work for the buoy
      5.7.4. Device of vacuum of the walk of a valve of butterfly of the secondary camera
      5.7.5. Substitution of a diaphragm of the valve of the economizador
      5.7.6. Automatic initial agreement
      5.7.7. Turns agreement of bystry to waste time
      5.7.8. Removal and installation of a damper of a valve of butterfly
      5.7.9. Adjust
   +5.8. System of injection of fuel
   5.9. Removal and installation of a collector of entry
+6. Union
+7. Transmissions
+8. Driving axle and rear bridge
+9. Direction
+10. Supports of the triangular form of interruption
+11. Brakes system
+12. Wheels and tires
+13. Body
+14. Electric equipment


bfe6b27a


5.7.1. Removal and installation of the carburator

GENERAL INFORMATION

Weber 2V carburator of TLD

ORDER OF REALIZATION
1. To withdraw a weight they connect of the accumulator.
2. To withdraw the case of the filter of air.
3. Desconectar wires of the sensor of explosion.
4. Desconectar wires of the heater of beginning the automatic equipment.
5. Desconectar hoses of offer and return of the fuel.
6. Desconectar to lever coulisse of the regulator connection.
7. Desconectar an electronic valve.
8. To withdraw a hose of system of cooling of a support of triangular form below the case of beginning the automatic equipment.
9. To unscrew four screws of Togkh, to withdraw the carburator and pure rags close an opening in an entry collector. To withdraw the placing.
10. The installation of the carburator is done in the sequence, the return to the removal. After the installation to adjust turns of wasting time and maintenance with.