FORD'S SCORPIO

1985-1994 of launch

Repair and operation of the car



Ford Skorpio
+1.1. Identification of the car
+ 2. Maintenance
- 3. Motors
   +3.1. Motor of OHC
   +3.2. Motor of DOHC
   -3.3. Motor of V6
      3.3.1. Technical characteristic
      3.3.2. The repair that does not demand the removal of the motor
      3.3.3. Removal of the motor
      -3.3.4. To be demolished and check of details of the motor
         3.3.4.1. Desmontagem of the motor
         3.3.4.2. Check of degree of use of details of the motor
         3.3.4.3. Knot of an axle of yokes
         3.3.4.4. Empurradores of valves and bar of empurradores
         3.3.4.5. Axle
         3.3.4.6. Leaders of the cylinder block
         3.3.4.7. Cylinders
         3.3.4.8. Check and restoration of pistons and rings of piston
         3.3.4.9. Fingers of piston and sticks
         3.3.4.10. Inclination end
         3.3.4.11. Radical loads and conrod
         3.3.4.12. Distributive gear wheels
         3.3.4.13. Pendulum
         +3.3.4.14. Lubrication system
         3.3.4.15. System of ventilation of a case
         +3.3.4.16. Meeting of the motor
         3.3.4.17. Agreement of slits of valves
         3.3.4.18. Auxiliary details of the motor
         3.3.4.19. Installation of the motor
         3.3.4.20. Launch of the motor after repairs of capital or restoration
      +3.3.5. Modifications in a drawing of motors V6 2,4 and 2,9 dm3
   +3.4. Systems of ignition and management of motor
   +3.5. Diesel engines
+4. System cooling
+5. Fuel system
+6. Union
+7. Transmissions
+8. Driving axle and rear bridge
+9. Direction
+10. Supports of the triangular form of interruption
+11. Brakes system
+12. Wheels and tires
+13. Body
+14. Electric equipment


bfe6b27a


3.3.4.13. Pendulum

ORDER OF REALIZATION
1. To check a pendulum to existence of damages, a garland of pendulum – in the existence of use and damages.
2. If the garland strongly was worn away or in her be an absent tooth, the garland must be substituted. The old garland can be withdrawn, when passed done in the drink between two teeths, and soon lower a chisel.
3. The installation of a new garland of gear in a pendulum demands the heating of one garland to 204 °C. there is executed by the uniform heating of a pendulum a hand blowpipe until the heated surfaces do not acquire a shadow clear-yellow.

Prevention

Not to overheat a garland, otherwise his force properties are going to be lost.


4. The garland has a tendentious interior of teeths what has to be turned to an author. When is the garland heated somewhat, to establish it quickly at the place, if necessary it will explore and cool in the natural way.