| 1. To compensate carefully for the inter-connected surfaces of a head of the cylinder block and the cylinder block. |
| 2. To install the new placing in the cylinder block. |
| 3. To become an end of inclination so that the pistons were installed in the middle of the course. |
| 4. To install a head of the cylinder block in the cylinder block. |
|
5. To polish with a fine layer of oil of motor a woodcarving of pins of the fixation of a head of the cylinder block (the firearms showed pins of M8 of the fixation of an advanced part of a head of the cylinder block), to establish them at the place and to hold tight the necessary moment in certain sequence (3.2.1 to see the subsection). |
| 6. To polish with a fine layer of oil of motor of a support of axles in a head and to install in place axles. |
| 7. To polish with a fine layer of oil of motor of a covering of loads of axles and to establish them at the place according to the marking. The coverings of loads of the axle of the managing director of valves of entry have the marking of R1-R5, and the coverings of loads of the axle of the managing director of final valves have the marking of L1-L5. Numeration of coverings of the walk of mechanism of distribution of gas. |
| 8. To install the oil pipeline of the provision of oil to axles cames. |
| 9. Gradually and constantly there insist nuts of the fixation of coverings of the fixation of axles on certain sequence. To the hand to hold tight nuts of fixation, turning them it is consecutive in 180 ° before the contact of a covering with a head of the cylinder block. Pressure sequence: L1 and R1, L5 and R5, L3 and R3. Then to put to the hand other armbands of the fixation of coverings. |
| 10. To hold tight nuts of the fixation of coverings the necessary moment, turning them in the same corner in the next sequence: L1 and R1, L5 and R5, L3 and R3, L2 and L4, R2 and R4. |
| 11. To establish a chain of the mechanism that distributes the gas and an asterisk (3.2.2.1 sees the subsection). |
| 12. To establish a covering of a head of the cylinder block with the new placing and to hold tight pins of the fixation of a covering constantly from the edge to the center. |
| 13. To support in spark captures. |
| 14. To install the distributor of ignition, a rotor of the distributor and a covering. |
| 15. To establish in wires of high voltage of place. |
| 16. To screw in a final collector a reception they exhaust the tube with the new placing. |
| 17. Wires adhere to an electric heater supporter. |
| 18. In cars with the system of the injection of the fuel in order that a wires braid adheres to the motor and lines of supply of fuel to press the regulator. |
| 19. To join hoses of vacuum and a thread of a gas pedal. |
| 20. There adheres a hose of the system of the ventilation of a case of the motor to a head of the cylinder block. |
| 21. To join a hose of the provision of cooling the liquid to a branch tube in a head of the cylinder block. |
| 22. To join a hose of an electric heater and a wide tank. |
| 23. To install the filter of air. |
| 24. To fill out the oil of motor in the motor. |
| 25. To fill out the cooling of liquid in the cooling system. |
| 26. To join a weight they connect to the accumulator. |
| 27. To begin the motor and if necessary it will adjust. |
