FORD'S SCORPIO

1985-1994 of launch

Repair and operation of the car

Ford Skorpio
+1.1. Identification of the car
+ 2. Maintenance
- 3. Motors
   +3.1. Motor of OHC
   -3.2. Motor of DOHC
      3.2.1. Technical characteristic
      -3.2.2. The repair that does not demand the removal of the motor
         3.2.2.1. Chain of the mechanism that distributes the gas and asterisks
         -3.2.2.2. Head of the cylinder block
            3.2.2.2.1. Removal of a head of the cylinder block
            3.2.2.2.2. To be demolished and meeting of a head of the cylinder block
            3.2.2.2.3. Check of a head of the cylinder block
            3.2.2.2.4. Check of the captures of direction of valves
            3.2.2.2.5. Processing of saddles of valves in a head of the cylinder block
            3.2.2.2.6. Grinding in
            3.2.2.2.7. Meeting of a head of the cylinder block
            3.2.2.2.8. Installation of a head of the cylinder block
         3.2.2.3. Removal and installation of a ring of rear fighter of an end of inclination
      +3.2.3. Removal and installation of the motor without transmission
      3.2.4. System of ventilation of a case
      +3.2.5. Lubrication system
   +3.3. Motor of V6
   +3.4. Systems of ignition and management of motor
   +3.5. Diesel engines
+4. System cooling
+5. Fuel system
+6. Union
+7. Transmissions
+8. Driving axle and rear bridge
+9. Direction
+10. Supports of the triangular form of interruption
+11. Brakes system
+12. Wheels and tires
+13. Body
+14. Electric equipment

3.2.2.2.6. Grinding in

GENERAL INFORMATION

To grind in of valves has to be done with the use alone of the briefcase of polishing of fine granulation.

ORDER OF REALIZATION

Quantity of briefcase to polish a surface of a saddle of the little valve with an and to install the valve in the corresponding saddle. To hold tight densely to a plate of the valve a cupping glass of rubber and to make spinning the valve in one or another party.

After the end of the process of the grinding in carefully for compensating for all the details of dirt and briefcase and to check a saddle and a plate of the valve. The continuous opaque ring in both details that specifies the width of facet of valve will be visible.

QX4.ONLINE
S40.ONLINE
A-8.ONLINE
W124.ONLINE
RX300.ONLINE
W140.ONLINE
B3-B4.SPACE
B3B4.SPACE
A-8.SPACE