FORD'S SCORPIO

1985-1994 of launch

Repair and operation of the car



Ford Skorpio
+1.1. Identification of the car
+ 2. Maintenance
- 3. Motors
   +3.1. Motor of OHC
   -3.2. Motor of DOHC
      3.2.1. Technical characteristic
      -3.2.2. The repair that does not demand the removal of the motor
         3.2.2.1. Chain of the mechanism that distributes the gas and asterisks
         -3.2.2.2. Head of the cylinder block
            3.2.2.2.1. Removal of a head of the cylinder block
            3.2.2.2.2. To be demolished and meeting of a head of the cylinder block
            3.2.2.2.3. Check of a head of the cylinder block
            3.2.2.2.4. Check of the captures of direction of valves
            3.2.2.2.5. Processing of saddles of valves in a head of the cylinder block
            3.2.2.2.6. Grinding in
            3.2.2.2.7. Meeting of a head of the cylinder block
            3.2.2.2.8. Installation of a head of the cylinder block
         3.2.2.3. Removal and installation of a ring of rear fighter of an end of inclination
      +3.2.3. Removal and installation of the motor without transmission
      3.2.4. System of ventilation of a case
      +3.2.5. Lubrication system
   +3.3. Motor of V6
   +3.4. Systems of ignition and management of motor
   +3.5. Diesel engines
+4. System cooling
+5. Fuel system
+6. Union
+7. Transmissions
+8. Driving axle and rear bridge
+9. Direction
+10. Supports of the triangular form of interruption
+11. Brakes system
+12. Wheels and tires
+13. Body
+14. Electric equipment


bfe6b27a


3.2.2.2.3. Check of a head of the cylinder block

ORDER OF REALIZATION
1. To check the planeness of a surface of a head of the cylinder block of that one inter-makes a list to the cylinder block through a line from steel and group of probes of measuring. If not planeness more than 0,05 mm for head of the cylinder block it is subject to the substitution.
2. To check a state and the diameter of loads of axles. If the diameter exceeds the extreme size, the head of the cylinder block is subject to the substitution.
3. To check a condition of necks and the cames of the axles.
4. To check a condition of surfaces of work of empurradores hydraulic of valves. In his considerable use in the operational time in the superior part of the motor there is a characteristic noise.
5. To check a state and the diameter of nests below empurradores hydraulic of valves. If the nests diameter exceeds the extreme size, the head of the cylinder block is subject to the substitution.