FORD'S SCORPIO

1985-1994 of launch

Repair and operation of the car

Ford Skorpio
+1.1. Identification of the car
+ 2. Maintenance
- 3. Motors
   +3.1. Motor of OHC
   -3.2. Motor of DOHC
      3.2.1. Technical characteristic
      -3.2.2. The repair that does not demand the removal of the motor
         3.2.2.1. Chain of the mechanism that distributes the gas and asterisks
         -3.2.2.2. Head of the cylinder block
            3.2.2.2.1. Removal of a head of the cylinder block
            3.2.2.2.2. To be demolished and meeting of a head of the cylinder block
            3.2.2.2.3. Check of a head of the cylinder block
            3.2.2.2.4. Check of the captures of direction of valves
            3.2.2.2.5. Processing of saddles of valves in a head of the cylinder block
            3.2.2.2.6. Grinding in
            3.2.2.2.7. Meeting of a head of the cylinder block
            3.2.2.2.8. Installation of a head of the cylinder block
         3.2.2.3. Removal and installation of a ring of rear fighter of an end of inclination
      +3.2.3. Removal and installation of the motor without transmission
      3.2.4. System of ventilation of a case
      +3.2.5. Lubrication system
   +3.3. Motor of V6
   +3.4. Systems of ignition and management of motor
   +3.5. Diesel engines
+4. System cooling
+5. Fuel system
+6. Union
+7. Transmissions
+8. Driving axle and rear bridge
+9. Direction
+10. Supports of the triangular form of interruption
+11. Brakes system
+12. Wheels and tires
+13. Body
+14. Electric equipment

3.2.2.2.2. To be demolished and meeting of a head of the cylinder block

GENERAL INFORMATION

Head of the cylinder block

1 - tubes of provision of oil to axles cames,
2 - coverings of loads of axles,
3 - managing director of axle of valves of entry,

4 - managing director of axle of final valves,
5 - head of the cylinder block,
6 - axles asterisks

ORDER OF REALIZATION

1. To arrange a head of the cylinder block in advanced and rear parts in two wooden grindstones.

2. It to remove a collector when of it entered together with the system of fuel and a tube of the removal of cooling the liquid (if they were not withdrawn before).

3. To unscrew a thermal covering, and soon a final collector.

4. To unscrew hair clips of hair of the fixation of both collectors.

5. To withdraw empurradores hydraulic of valves and to put them in containeres correspondents with the oil of the installation besides that repeated at the places (if they were not withdrawn before).

6. The special adaptation to insist on the valves spring order and to take fine cookies of the fixation of a persistent superior plate of one spring. To withdraw the superior plate and the springs of the valve, paying attention to damaging valve nucleuses.

7. To take the valve of the camera of combustion.

8. To withdraw hats maslootrazhatelny of the captures of direction of valves.