FORD'S SCORPIO

1985-1994 of launch

Repair and operation of the car

Ford Skorpio
+1.1. Identification of the car
+ 2. Maintenance
- 3. Motors
   -3.1. Motor of OHC
      3.1.1. Technical characteristic
      -3.1.2. Service and repair
         3.1.2.1. Agreement of the motor
         +3.1.2.2. The repair that does not demand the removal of the motor
         3.1.2.3. Removal and installation of the motor
         -3.1.2.4. Repair of the motor
            3.1.2.4.1. Desmontagem of the motor
            3.1.2.4.2. Identification of the parts they interact
            3.1.2.4.3. Meeting of the motor
            3.1.2.4.4. Pistons substitution
            3.1.2.4.5. Removal and installation of an intermediary end
            3.1.2.4.6. System of distribution of gas
            3.1.2.4.7. Launch of the motor after capital repairs
         3.1.2.5. Lubrication system
         3.1.2.6. System of ventilation of a case
   +3.2. Motor of DOHC
   +3.3. Motor of V6
   +3.4. Systems of ignition and management of motor
   +3.5. Diesel engines
+4. System cooling
+5. Fuel system
+6. Union
+7. Transmissions
+8. Driving axle and rear bridge
+9. Direction
+10. Supports of the triangular form of interruption
+11. Brakes system
+12. Wheels and tires
+13. Body
+14. Electric equipment

3.1.2.4.6. System of distribution of gas

GENERAL INFORMATION

Substitution of a ring of fighter of an axle

ORDER OF REALIZATION

1. Desconectar a wire of the weight of the accumulator and to fuse the liquid of the system of cooling (4.2.1 to see the subsection).

2. Desconectar the top and to lower the elastic oil pipeline of an electric heater.

3. To withdraw a covering of a belt of gear. To weaken pins of the fixation of the device of tension, to move his roll, surpassing the spring resistance and to hold tight pins of the fixation of the device of tension (to see the rice. Removal of the device of tension of a belt of gear through a few 21.012-key).

4. To take away a belt of gear.

5. To withdraw a pulley and a basic plate of the longitudinal installation of an axle.

6. 21.008 withdraws a ring of fighter of an axle through the adaptation.

7. To the oil a new ring of fighter of an axle, in order that 21.009 to install it in the adaptation To and in order that a ring insists on a head of the cylinder block.

8. To establish in the distributive one to an end a basic plate and a pulley.

9. To put a belt of gear, to establish the end operated with crank and distributive in etiquettes (to see the rice. To adjust signs of system of distribution of gas).

10. To pull a belt of gear through the device of tension (to see the rice. Removal of the device of tension of a belt of gear through a few 21.012-key).

11. To establish a covering of a belt of gear.

There adhere to an electric heater elastic oil pipelines of the system of cooling (I come across and more low).

To fill the system of cooling of the liquid and to withdraw of him the air.

To join a weight they connect to the accumulator.

Removal and installation of an axle and installation of distribution of gas

These actions are described in the section (3.1.2.2.3 and the subsection see the subsection 3.1.2.2.1).