FORD'S SCORPIO

1985-1994 of launch

Repair and operation of the car



Ford Skorpio
+1.1. Identification of the car
+2. Maintenance
+3. Motors
+ 4. System cooling
- 5. Fuel system
   5.1. Technical characteristic
   5.2. Fuel
   5.3. Gasoline without lead of V6, 2,4 motors and 2,9 dm3
   -5.4. System of air provision
      5.4.1. Removal and installation of the filter of air
      5.4.2. Temperature regulator
      5.4.3. Fuel bomb
      5.4.4. The substitution of the fuel filters in motors with the system of the injection of the fuel
      5.4.5. Removal and installation of the tank of fuel
      5.4.6. Removal and installation of the sensor of measurement of level of fuel
      5.4.7. Removal and installation of the switch inercial of fuel provision
      5.4.8. Removal and installation of a pedal of a gas pedal
      5.4.9. Removal and installation of a thread of a gas pedal
      5.4.10. Separator to steam
   +5.5. Carburator of PIERBURG
   +5.6. WEBER 2V carburator
   +5.7. WEBER 2V carburator of TLD
   +5.8. System of injection of fuel
   5.9. Removal and installation of a collector of entry
+6. Union
+7. Transmissions
+8. Driving axle and rear bridge
+9. Direction
+10. Supports of the triangular form of interruption
+11. Brakes system
+12. Wheels and tires
+13. Body
+14. Electric equipment


bfe6b27a


5.4.5. Removal and installation of the tank of fuel

GENERAL INFORMATION

It is possible to withdraw the tank of fuel after the use of full fuel or in the presence of the bomb bomb it had been special.

ORDER OF REALIZATION
1. To withdraw a weight they connect of the accumulator.
2. In the presence in a fuel tank to pump it it had gone to special bomb.
3. To unscrew two screws of each side of a mouth of the tank of fuel.
4. To lift a rear part of the car and to register in supports.
5. To remove a policeman of an internal arch of right behind goes round and the lowest fabric of bumpers bottom that fixes six screws.
6. To withdraw the offer and repayable lines of supply of fuel of the tank of fuel.
7. Property of the tank of fuel, to unscrew two pins of the rear bearer of the fixation of a tank.
8. To lower the tank of fuel with the property levels, to unhook the advanced ends of levels of locks.
9. Desconectar a wire of the sensor of level of fuel.
10. Desconectar a hose of ventilation of the tank of fuel.
11. To withdraw the tank of fuel with the mouth of volume annexed to him.
12. The installation is done in the sequence, the return to the removal.