FORD'S SCORPIO

1985-1994 of launch

Repair and operation of the car

Ford Skorpio
+1.1. Identification of the car
+2. Maintenance
+3. Motors
+ 4. System cooling
- 5. Fuel system
   5.1. Technical characteristic
   5.2. Fuel
   5.3. Gasoline without lead of V6, 2,4 motors and 2,9 dm3
   -5.4. System of air provision
      5.4.1. Removal and installation of the filter of air
      5.4.2. Temperature regulator
      5.4.3. Fuel bomb
      5.4.4. The substitution of the fuel filters in motors with the system of the injection of the fuel
      5.4.5. Removal and installation of the tank of fuel
      5.4.6. Removal and installation of the sensor of measurement of level of fuel
      5.4.7. Removal and installation of the switch inercial of fuel provision
      5.4.8. Removal and installation of a pedal of a gas pedal
      5.4.9. Removal and installation of a thread of a gas pedal
      5.4.10. Separator to steam
   +5.5. Carburator of PIERBURG
   +5.6. WEBER 2V carburator
   +5.7. WEBER 2V carburator of TLD
   +5.8. System of injection of fuel
   5.9. Removal and installation of a collector of entry
+6. Union
+7. Transmissions
+8. Driving axle and rear bridge
+9. Direction
+10. Supports of the triangular form of interruption
+11. Brakes system
+12. Wheels and tires
+13. Body
+14. Electric equipment

5.4.2. Temperature regulator

GENERAL INFORMATION

The diaphragm of vacuum that makes working the door of agreement of temperature of the air that comes to the motor

The vacuum diaphragm is specified by an arrow.

Agreement of thermal valve in case of the filter of air

The thermal valve is specified by an arrow.

In motors with the carburator the temperature regulator maintains the air temperature, coming to the air filter, inside 25-35 °C.

The door in a tube of branch of the let one breathe supplies the provision of hot or cold air. A vacuum diaphragm one makes work the door, pass reacts to inhale in an entry collector. The entry of the vacuum at the door is regulated by the thermal valve located in case of the filter of air.

To check

ORDER OF REALIZATION

1. It is necessary to begin the check of a regulator of temperature in the cold motor. In the motor disconnected the door of a regulator of temperature it has to be closed completely. It is possible to define the position of the door so much of the filter, as of an air entry.

2. To begin the motor and to check that the door completely opens to waste time, initial provision of the air that is heated by a final collector in the air filter.

3. In case of what after the launch of the motor the door of a regulator of temperature remains closed, it is necessary to check a regulator of temperature and a membrane.