FORD'S SCORPIO

1985-1994 of launch

Repair and operation of the car

Of wasting time not always the unequal and unstable turns demonstrate the failure of the motor of step. It is previously necessary to check the confidence of the contact between a diver and the screw of agreement.

Provisions of a diver of the motor of step

ORDER OF REALIZATION

1. To withdraw a negative wire of the accumulator. 2. To withdraw the filter of air. 3. Desconectar the capture of multiproduction of the motor of step. 4. To unscrew four screws that fix a support of the triangular form of interruption of the motor of step to the carburator. 5. To withdraw motor together with a support of the triangular form of interruption. 6. To install the motor of step, to crush four screws and to join the capture. 7. Execute the initial agreement of the screw of the lever of a regulator that the head of screw was in the distance of 7,5 mm of the lever. 8. To join a hose of vacuum of the filter of air. To put the filter of air to the part so that there was an access to the carburator and the motor of step. 9. To join a tacômetro according to the education. 10. To join the accumulator. 11. To begin the motor and to check and if necessary the quality of the mixture will adjust. 12. Desconectar everything electric consumers. In case of what is the wire of the agreement of wasting time tied to the land, to isolate it temporarily. To check that the lever of the choice of transfers of the automatic exchange is in situation N or Ruble. 13. To increase turns of motor to 2.500 revolutions per minute and to return to turns waste time, soon to repeat the cycle. To insert an edge of the probe of 1,0 mm of thickness between a diver of the motor of step and the screw of agreement, at the same time the turns of the motor will be inside 875 ± 25 revolutions per minute. 14. To execute the agreement to withdraw a protective hat, to launch a countersow and to make spinning the screw of agreement to establish the turns they waste time necessary. 15. To take a spilling of edge, to stop and to restart the movement of observation of motor of a diver of the motor of step. After a motor stop the diver has to move for a zone of antiexplosion (to clean in the step motor), and during several seconds to move for the regulator lever. 16. Desconectar a tacômetro and to install at the place the filter of air. 17. To check repeatedly the quality of the mixture. 18. To join repeatedly a wire of the agreement of turns of wasting time.