FORD'S SCORPIO

1985-1994 of launch

Repair and operation of the car


Ford Skorpio
+1.1. Identification of the car
+ 2. Maintenance
- 3. Motors
   +3.1. Motor of OHC
   +3.2. Motor of DOHC
   +3.3. Motor of V6
   -3.4. Systems of ignition and management of motor
      3.4.1. Technical characteristic
      -3.4.2. Systems of ignition and management of motor
         3.4.2.1. System of ignition of ESC II
         3.4.2.2. System of ignition of EEC IV
         3.4.2.3. Ignition distributor
         3.4.2.4. Check of an angle of installation of an advancement of ignition
         3.4.2.5. The block of ignition (models with system of injection of fuel)
         3.4.2.6. Ignition roll
         3.4.2.7. A fuel capture in motors with the carburator
         3.4.2.8. Unity of control of the motor
         3.4.2.9. Motor of step of the carburator
         3.4.2.10. The device of heating of a collector of entry of motors with the carburator
         3.4.2.11. Alternation of a system of control of the motor
         3.4.2.12. Installation of a corner of an advancement of ignition and turns of wasting time
         3.4.2.13. Meter of REVOLUTIONS PER MINUTE and provisions of an end of inclination
         3.4.2.14. Air temperature sensor
         3.4.2.15. Sensor of temperature of fuel
         3.4.2.16. Sensor of speed of the car
         3.4.2.17. The sensor of absolute pressure in a collector (MAP)
   +3.5. Diesel engines
+4. System cooling
+5. Fuel system
+6. Union
+7. Transmissions
+8. Driving axle and rear bridge
+9. Direction
+10. Supports of the triangular form of interruption
+11. Brakes system
+12. Wheels and tires
+13. Body
+14. Electric equipment


bfe6b27a


3.4.2.10. The device of heating of a collector of entry of motors with the carburator
GENERAL INFORMATION
Prevention

Not to withdraw the device of the heating of a collector of entry in a heated state.

ORDER OF REALIZATION
1. To withdraw a negative wire of the accumulator.
2. For the improvement of the access to withdraw the case of the filter of air.
3. To unscrew three pins of the fixation of the device of the heating of a collector of entry that fix the device to a reverse side of a collector.
4. Desconectar wires of the device of the heating of a collector of entry.
5. To withdraw the device of the heating of a collector of entry (it is specified by an arrow).