FORD'S SCORPIO

1985-1994 of launch

Repair and operation of the car



Ford Skorpio
+1.1. Identification of the car
+ 2. Maintenance
- 3. Motors
   +3.1. Motor of OHC
   +3.2. Motor of DOHC
   +3.3. Motor of V6
   -3.4. Systems of ignition and management of motor
      3.4.1. Technical characteristic
      -3.4.2. Systems of ignition and management of motor
         3.4.2.1. System of ignition of ESC II
         3.4.2.2. System of ignition of EEC IV
         3.4.2.3. Ignition distributor
         3.4.2.4. Check of an angle of installation of an advancement of ignition
         3.4.2.5. The block of ignition (models with system of injection of fuel)
         3.4.2.6. Ignition roll
         3.4.2.7. A fuel capture in motors with the carburator
         3.4.2.8. Unity of control of the motor
         3.4.2.9. Motor of step of the carburator
         3.4.2.10. The device of heating of a collector of entry of motors with the carburator
         3.4.2.11. Alternation of a system of control of the motor
         3.4.2.12. Installation of a corner of an advancement of ignition and turns of wasting time
         3.4.2.13. Meter of REVOLUTIONS PER MINUTE and provisions of an end of inclination
         3.4.2.14. Air temperature sensor
         3.4.2.15. Sensor of temperature of fuel
         3.4.2.16. Sensor of speed of the car
         3.4.2.17. The sensor of absolute pressure in a collector (MAP)
   +3.5. Diesel engines
+4. System cooling
+5. Fuel system
+6. Union
+7. Transmissions
+8. Driving axle and rear bridge
+9. Direction
+10. Supports of the triangular form of interruption
+11. Brakes system
+12. Wheels and tires
+13. Body
+14. Electric equipment


bfe6b27a


3.4.2.17. The sensor of absolute pressure in a collector (MAP)

GENERAL INFORMATION

The sensor of the absolute pressure in a collector (the MAP) of the cars is equipped of the catalyst


The sensor is located in the right advanced side of a driving compartment. In motors V6 the sensor is located in the center of a splitting of a driving compartment.

ORDER OF REALIZATION
1. To withdraw a negative wire of the accumulator.
2. To unscrew two screws of the fixation of the sensor.
3. Desconectar the capture of the sensor, soon desconectar a vacuum hose and to withdraw the sensor.