FORD'S SCORPIO

1985-1994 of launch

Repair and operation of the car

Ford Skorpio
+1.1. Identification of the car
+ 2. Maintenance
- 3. Motors
   +3.1. Motor of OHC
   +3.2. Motor of DOHC
   +3.3. Motor of V6
   -3.4. Systems of ignition and management of motor
      3.4.1. Technical characteristic
      -3.4.2. Systems of ignition and management of motor
         3.4.2.1. System of ignition of ESC II
         3.4.2.2. System of ignition of EEC IV
         3.4.2.3. Ignition distributor
         3.4.2.4. Check of an angle of installation of an advancement of ignition
         3.4.2.5. The block of ignition (models with system of injection of fuel)
         3.4.2.6. Ignition roll
         3.4.2.7. A fuel capture in motors with the carburator
         3.4.2.8. Unity of control of the motor
         3.4.2.9. Motor of step of the carburator
         3.4.2.10. The device of heating of a collector of entry of motors with the carburator
         3.4.2.11. Alternation of a system of control of the motor
         3.4.2.12. Installation of a corner of an advancement of ignition and turns of wasting time
         3.4.2.13. Meter of REVOLUTIONS PER MINUTE and provisions of an end of inclination
         3.4.2.14. Air temperature sensor
         3.4.2.15. Sensor of temperature of fuel
         3.4.2.16. Sensor of speed of the car
         3.4.2.17. The sensor of absolute pressure in a collector (MAP)
   +3.5. Diesel engines
+4. System cooling
+5. Fuel system
+6. Union
+7. Transmissions
+8. Driving axle and rear bridge
+9. Direction
+10. Supports of the triangular form of interruption
+11. Brakes system
+12. Wheels and tires
+13. Body
+14. Electric equipment

3.4.2.5. The block of ignition (models with system of injection of fuel)

V6 OHC I MOTORES

ORDER OF REALIZATION

1. To withdraw a negative wire of the accumulator.
2. Desconectar the capture of multiproduction of the distributor of ignition.
3. In the models V6 to put etiquettes of combination between the case of the distributor of the ignition and the motor. To weaken a pin of the fixation of the distributor of the ignition and to turn the distributor of ignition of the access to screws of the fixation of the block of the ignition.
	4. To unscrew two screws of the fixation of the block of the ignition (they are specified by firearms), to move the block I lower and to withdraw it of the ignition distributor.
5. Before the installation at the place of applying Ford who drives the heat 815F-12103-AA they stick in a rear part of the block.
6. To install the block of ignition at the place and to fix for two screws.
7. In the models V6 to return the distributor of ignition in the initial situation, to check the installation of a corner of an advancement of the ignition and to hold tight a pin of fixation.
8. To join the capture of multiproduction of the distributor of the ignition.

MOTOR OF DOHC

Block of ignition of motor of DOHC

The block of the ignition is located in the left advanced corner of a driving compartment, on the case of the filter of air.

ORDER OF REALIZATION

1. To withdraw a negative wire of the accumulator.

2. For the improvement of the access to withdraw the case of the filter of air.

3. To withdraw the capture of the block of ignition.

4. To unscrew two screws and to withdraw the block of a driving compartment.