FORD'S SCORPIO

1985-1994 of launch

Repair and operation of the car



Ford Skorpio
+1.1. Identification of the car
+ 2. Maintenance
- 3. Motors
   +3.1. Motor of OHC
   +3.2. Motor of DOHC
   +3.3. Motor of V6
   -3.4. Systems of ignition and management of motor
      3.4.1. Technical characteristic
      -3.4.2. Systems of ignition and management of motor
         3.4.2.1. System of ignition of ESC II
         3.4.2.2. System of ignition of EEC IV
         3.4.2.3. Ignition distributor
         3.4.2.4. Check of an angle of installation of an advancement of ignition
         3.4.2.5. The block of ignition (models with system of injection of fuel)
         3.4.2.6. Ignition roll
         3.4.2.7. A fuel capture in motors with the carburator
         3.4.2.8. Unity of control of the motor
         3.4.2.9. Motor of step of the carburator
         3.4.2.10. The device of heating of a collector of entry of motors with the carburator
         3.4.2.11. Alternation of a system of control of the motor
         3.4.2.12. Installation of a corner of an advancement of ignition and turns of wasting time
         3.4.2.13. Meter of REVOLUTIONS PER MINUTE and provisions of an end of inclination
         3.4.2.14. Air temperature sensor
         3.4.2.15. Sensor of temperature of fuel
         3.4.2.16. Sensor of speed of the car
         3.4.2.17. The sensor of absolute pressure in a collector (MAP)
   +3.5. Diesel engines
+4. System cooling
+5. Fuel system
+6. Union
+7. Transmissions
+8. Driving axle and rear bridge
+9. Direction
+10. Supports of the triangular form of interruption
+11. Brakes system
+12. Wheels and tires
+13. Body
+14. Electric equipment


bfe6b27a


3.4.2.16. Sensor of speed of the car

GENERAL INFORMATION

The sensor is located in the left side of the transmission.
ORDER OF REALIZATION
1. To withdraw a negative wire of the accumulator.
2. The access is the most available thing of below of the car. To lift an advanced part of the car and to register in supports.
3. To separate the capture of electrical system of sensor (it is specified by an arrow) of a support of the triangular form of interruption and desconectar the capture.
4. To unscrew a pin of the fixation and to withdraw a support of the triangular form of interruption of capture, at the same time having observed his situation.
5. To take the sensor of a case of transmission.