FORD'S SCORPIO

1985-1994 of launch

Repair and operation of the car

Ford Skorpio
+1.1. Identification of the car
+2. Maintenance
+3. Motors
+ 4. System cooling
- 5. Fuel system
   5.1. Technical characteristic
   5.2. Fuel
   5.3. Gasoline without lead of V6, 2,4 motors and 2,9 dm3
   +5.4. System of air provision
   -5.5. Carburator of PIERBURG
      5.5.1. Turns agreement of wasting time and quality of mixture
      5.5.2. Agreement of a damper of a valve of butterfly of the first camera
      5.5.3. Agreement of an initial slit of the air door
      5.5.4. Removal and installation of the carburator
      5.5.5. Desmontagem of the carburator
      5.5.6. Meeting of the carburator
      5.5.7. Adjust of bystry to waste time
      5.5.8. Modifications of Pierburg 2V carburator from September of 1986
   +5.6. WEBER 2V carburator
   +5.7. WEBER 2V carburator of TLD
   +5.8. System of injection of fuel
   5.9. Removal and installation of a collector of entry
+6. Union
+7. Transmissions
+8. Driving axle and rear bridge
+9. Direction
+10. Supports of the triangular form of interruption
+11. Brakes system
+12. Wheels and tires
+13. Body
+14. Electric equipment

5.5.8. Modifications of Pierburg 2V carburator from September of 1986

GENERAL INFORMATION

^{Pierburg made an upgrade 2V installed carburator in last motors 1,8 of dm3}

1 - the hose of fuel of offer,

2 - an agreement of the clip with hinges vertical rotifer,

3 - diaphragm hose,

4 - valve of unloading of vacuum of control of the door of the secondary camera

The electric connections of Pierburg made an upgrade 2V installed carburator in last motors 1,8 of dm3

1 - wires braid,

2 - vacuum of unity of control that deposits door of valve of the secondary camera,

3 - base,

4 - initial connection of the roll of ignition

In motors from September of 1986 the modified carburator that includes the diaphragm ottyazhny secondary of the door that reduces consumption of fuel is installed. If the carburator made an upgrade has to be installed in more advanced models, always use the new placing and execute the next operations:

– a special thread joins the capture;
– desconectar a positive wire of the roll of the ignition and to adhere taken of a new thread to the positive contact of the roll and the wire left the positive potential;
– to join a braid they establish the contact to one of screws of the fixation of the roll of the ignition.