FORD'S SCORPIO

1985-1994 of launch

Repair and operation of the car

Ford Skorpio
+1.1. Identification of the car
+2. Maintenance
+3. Motors
+ 4. System cooling
- 5. Fuel system
   5.1. Technical characteristic
   5.2. Fuel
   5.3. Gasoline without lead of V6, 2,4 motors and 2,9 dm3
   +5.4. System of air provision
   -5.5. Carburator of PIERBURG
      5.5.1. Turns agreement of wasting time and quality of mixture
      5.5.2. Agreement of a damper of a valve of butterfly of the first camera
      5.5.3. Agreement of an initial slit of the air door
      5.5.4. Removal and installation of the carburator
      5.5.5. Desmontagem of the carburator
      5.5.6. Meeting of the carburator
      5.5.7. Adjust of bystry to waste time
      5.5.8. Modifications of Pierburg 2V carburator from September of 1986
   +5.6. WEBER 2V carburator
   +5.7. WEBER 2V carburator of TLD
   +5.8. System of injection of fuel
   5.9. Removal and installation of a collector of entry
+6. Union
+7. Transmissions
+8. Driving axle and rear bridge
+9. Direction
+10. Supports of the triangular form of interruption
+11. Brakes system
+12. Wheels and tires
+13. Body
+14. Electric equipment

5.5.4. Removal and installation of the carburator

ORDER OF REALIZATION

1. To withdraw a weight they connect of the accumulator.
2. To withdraw the filter of air.
3. Desconectar a wire of the automatic air door of a thermoswitch.
	4. Desconectar an arm of regulator (it is specified by an arrow) of the lever.
5. To withdraw a hose of the provision of the fuel in the carburator. In the presence in hoses of collars of union to bite them and instead of them to establish the collars that corset themselves the screw.
6. In the hot motor to take away the pressure in the system of cooling of motor for what, care that has, to unscrew a cork in a wide tank.
	7. To withdraw hoses of the provision of cooling the liquid of the case of the automatic air door, lifting them and deadening traffic jams of traffic (it is shown by an arrow).
8. To unscrew three screws of the fixation of the carburator to an entry collector.
9. To withdraw the carburator and pure rags close an opening in an entry collector.
10. The installation of the carburator is done in the sequence, the return to the removal. After the installation to adjust turns of wasting time and maintenance with.