FORD'S SCORPIO

1985-1994 of launch

Repair and operation of the car

Ford Skorpio
+1.1. Identification of the car
+2. Maintenance
+3. Motors
+ 4. System cooling
- 5. Fuel system
   5.1. Technical characteristic
   5.2. Fuel
   5.3. Gasoline without lead of V6, 2,4 motors and 2,9 dm3
   +5.4. System of air provision
   -5.5. Carburator of PIERBURG
      5.5.1. Turns agreement of wasting time and quality of mixture
      5.5.2. Agreement of a damper of a valve of butterfly of the first camera
      5.5.3. Agreement of an initial slit of the air door
      5.5.4. Removal and installation of the carburator
      5.5.5. Desmontagem of the carburator
      5.5.6. Meeting of the carburator
      5.5.7. Adjust of bystry to waste time
      5.5.8. Modifications of Pierburg 2V carburator from September of 1986
   +5.6. WEBER 2V carburator
   +5.7. WEBER 2V carburator of TLD
   +5.8. System of injection of fuel
   5.9. Removal and installation of a collector of entry
+6. Union
+7. Transmissions
+8. Driving axle and rear bridge
+9. Direction
+10. Supports of the triangular form of interruption
+11. Brakes system
+12. Wheels and tires
+13. Body
+14. Electric equipment

5.5.6. Meeting of the carburator

ORDER OF REALIZATION

1. The meeting of the carburator is done in the sequence, the return to the removal, with the application of new placing and consolidations.

2. During the installation of the case of one spring bimetálica to combine etiquettes.

3. For the check of the opening of the air door to install the screw that wastes time in the superior step of a came. To hold tight the screw of agreement towards a diaphragm and to measure the opening of the door through a furadeira or a nucleus of measuring of the nominal diameter. The slit will be the same as 3 mm. If necessary the agreement will execute, using the 2 mm hexagon for key.

4. After the installation of a damper of a valve of butterfly of the first camera to adjust his situation in a support of triangular form that between the screw of agreement of turns of wasting time and a few valves of butterfly of lever of control to probe of 2 mm of thickness entered. The diver of a damper will concern the lever of driving only.

5. To adjust turns of wasting time and quality of the mixture, and if necessarily – and you turn of bystry to waste time.