FORD'S SCORPIO

1985-1994 of launch

Repair and operation of the car


Ford Skorpio
+1.1. Identification of the car
+ 2. Maintenance
- 3. Motors
   -3.1. Motor of OHC
      3.1.1. Technical characteristic
      -3.1.2. Service and repair
         3.1.2.1. Agreement of the motor
         -3.1.2.2. The repair that does not demand the removal of the motor
            3.1.2.2.1. Removal and installation of a belt of gear
            3.1.2.2.2. Removal of a head of the cylinder block
            3.1.2.2.3. To be demolished and meeting of a head of the cylinder block
            3.1.2.2.4. Installation of a head of the cylinder block
            3.1.2.2.5. Removal and installation of the trundle bed of oil
            3.1.2.2.6. Substitution of a ring of advanced fighter of an end of inclination
            3.1.2.2.7. Substitution of a ring of rear fighter of an end of inclination
            3.1.2.2.8. Substitution of support of the motor
         3.1.2.3. Removal and installation of the motor
         +3.1.2.4. Repair of the motor
         3.1.2.5. Lubrication system
         3.1.2.6. System of ventilation of a case
   +3.2. Motor of DOHC
   +3.3. Motor of V6
   +3.4. Systems of ignition and management of motor
   +3.5. Diesel engines
+4. System cooling
+5. Fuel system
+6. Union
+7. Transmissions
+8. Driving axle and rear bridge
+9. Direction
+10. Supports of the triangular form of interruption
+11. Brakes system
+12. Wheels and tires
+13. Body
+14. Electric equipment


bfe6b27a


3.1.2.2.5. Removal and installation of the trundle bed of oil

Removal

ORDER OF REALIZATION
1. To withdraw a negative wire of the accumulator.
2. To lift and to register an advanced part of the car.
3. To withdraw the protection of a case and to fuse the oil of motor.
4. To remove an author.
5. To unscrew two nuts of the fixation of arms of the motor to support.
6. To weaken pins of the hinge cardan of a direction end, having supplied his mutual mobility.
7. Advanced schoolmistress withdraws tubes of brake of clips in a beam. To hook up to the motor the mechanism that lifts the load and to stand up so that the weight of the motor was realized by the mechanism that lifts the load.
8. To establish a monkey below an advanced ray, to withdraw pins of the support of a ray and carefully lowered of a monkey, to lower a ray.
9. To unscrew 23 pins of the fixation of the trundle bed and to withdraw the trundle bed.
10. To withdraw the placing of the trundle bed of oil.

Installation

ORDER OF REALIZATION
1. To apply the selante in corners of adjusting surfaces of advanced and rear consolidations and to establish consolidations in flutes of a covering of the rear load and a covering of the advanced load of an end of inclination.
2. To apply the selante in the inter-connected surface in the cylinder block, to install the placing of the trundle bed in the cylinder block, having hooked up to the ends of the placing of the lowest part of consolidations.
3. To install the trundle bed of oil and to hold tight pins the necessary moment. To hold tight pins around the moment of 1-2 nanômetros, what they begin with a point E, then the moment of 6-8 nanômetros, what begin with a point in and to hold tight finally the moment 8-10 nanômetros during 20 minutes of the operation of the motor.