FORD'S SCORPIO

1985-1994 of launch

Repair and operation of the car

3.1.2.2.2. Removal of a head of the cylinder block

GENERAL INFORMATION

Knot of a head of the cylinder block

1 - covering of a head of the cylinder block,
2 - plates pressure,
3 - placing of a covering,
4 - axle,
5 - agreement of plate of the axle,
6 - pin of fixation of a head,
7 - spring of lever of valve,
8 - valve lever,
9 - a pin with a spherical tip (a support of lever of valve),
10 - fine cookies,

11 - plate of one spring,
12 - the direction capture,
14 - valve,
15 - taken of loads of the axle,
16 - the oil pipeline of provision of oil to axle loads,
17 - placing of a head of the cylinder block,
18 - head of the cylinder block,
19 - fighter of ring of the axle

Knot of the filter of air

1 - I marry,

2 - covering,

3 - the filtration element,

4 - wavy hose of an air entry,

5 - air entry of hot air

ORDER OF REALIZATION

1. For desconectar they connect a weight of the accumulator.

2. To fuse the liquid that cools of the cooling system.

3. To withdraw the filter of air, desconectar oil pipelines and sketches of the carburator and a collector of entry.

4. Desconectar electric wires of the carburator and a head of the cylinder block.

5. Desconectar of captures of spark of a wire of the high voltage and to remove the distributor of the high voltage.

6. Desconectar oil pipelines of cooling the liquid of the camera of the initial agreement of the carburator, the best hose of an electric heater, and also a hose of a wide tank of a head of the cylinder block.

7. For desconectar a reception they exhaust the tube of a final collector (3 nuts).

8. To withdraw the covering of protection of a belt of gear of the system of the distribution of gas (3 pins), and also a covering of a head of the cylinder block (10 pins) together with his selante.

9. To install the piston of 1 cylinder in the superior dead point, becoming an end of inclination of a pin, the pulley of fixation of a belt of side, in the direction of the rotation of work up to the etiquette of the superior dead point it does not go with an etiquette in a covering of a ring of advanced fighter of an end of inclination, and the etiquette in a pulley of an axle will not go with an etiquette in a head of the cylinder block. To observe the provision of a rotor of the distributor regarding the distributor's case so that it will discover the distributor who having lifts the screwdriver 2 side that fixes supports of triangular form and having unscrews 2 screws of the fixation of a covering.

10. To unscrew the fixation of the device of tension of a belt of gear of the system of the distribution of gas (adaptation 21.012), to weaken it and to corset itself in this situation.

11. To take away a belt of gear of the system of the distribution of gas.

12. To unscrew taken of spark, and also to unscrew pins of a head of the cylinder block (adaptation 21.002) in the sequence in front of his pressure.

13. To withdraw a head of the cylinder block of the cylinder block of the motor.

Prevention

There is not necessary the lowest airplane has a head of the cylinder block in a horizontal surface like threat of the damage of speakers' valves below of the airplane. A head of the cylinder block that is necessary to have in two wooden grindstones so that the valves plates did not concern anything.