FORD'S SCORPIO

1985-1994 of launch

Repair and operation of the car

3.1.2.2.4. Installation of a head of the cylinder block

GENERAL INFORMATION

Order of pressure of pins of fixation of a head of the cylinder block

Placing of placing of a covering of a head of the cylinder block

ORDER OF REALIZATION

1. To the clear placing the prileganiye surfaces in the best airplane of the cylinder block and the lowest airplane of a head of the cylinder block.

2. To crush pins of agreement (adaptation 21.003) in the cylinder block and to establish the new placing of a head of the cylinder block (to see the rice. Placing of placing of a covering of a head of the cylinder block).

3. To establish a head of the cylinder block. His pins to twist in in available openings a hand, to substitute pins of agreement with other pins of the fixation of a head of the cylinder block.

4. A stage holds tight pins of a head of the cylinder block (adaptation 21.002) in the three first, observing the corresponding order of his pressure (to see the rice. Order of pressure of pins of fixation of a head of the cylinder block).

5. To establish according to the agreement of pulleys of signs in the doubled and distributive end.

6. To install the distributor of ignition, a belt of gear and desbloquear the device of tension of a belt of gear.

Prevention

After the installation of a belt of gear it is possible to make spinning an end of inclination only in the direction in which the end revolves during the operation of the motor.

7. To establish a covering of a head of the cylinder block and to hold tight pins according to the recommended order (to see the rice. Order of pressure of pins of a covering of a head of the cylinder block).

8. To crush taken of spark, to screw a covering of a belt of gear and to annex a reception they exhaust the tube to a final collector.

9. To install the distributor of the high voltage in the ignition distributor and to annex wires of the high voltage to the corresponding spark captures.

10. A vacuum hose adheres to the carburator, and also the oil pipelines of the offer and removal of cooling the liquid to the case of the automatic initial agreement of the carburator.

11. There adheres the oil pipeline of the ventilation of the transmission to an oil separator.

12. To join the oil pipeline of the amplifier of vacuum of brakes and a thread of a pedal of a gas pedal.

13. To join hoses: I come across and more low to a wide tank and to fill the system of cooling of the liquid to seize the level.

14. To adhere a wire of the mass of the car to the accumulator and to establish the lowest covering.

15. To begin the motor and to heat it up to the work temperature.

16. Advanced corner, speed adjust an ignition of wasting time and concentration with in leak gases.

17. After being heated of the motor to discover a head of the cylinder block and desconectar wires of the high voltage of captures of spark.

18. There insist pins of a head of the cylinder block (adaptation 21.002) on the order happened in the rice. Order of pressure of pins of fixation of a head of the cylinder block.

19. To establish a covering of a head of the cylinder block, observing the corresponding sequence during the pressure (to see the rice. The order of the pressure of pins of a covering of a head of the cylinder block) and to join wires of the high voltage to sparkle taken.

20. To install the filter of air.