FORD'S SCORPIO

1985-1994 of launch

Repair and operation of the car



Ford Skorpio
+1.1. Identification of the car
+2. Maintenance
+3. Motors
+4. System cooling
+5. Fuel system
+ 6. Union
- 7. Transmissions
   +7.1. Mechanical transmission of five speeds of type of N
   +7.2. Mechanical MT 75 transmission
   -7.3. Transmission A4LD automatic
      7.3.1. Technical characteristic
      -7.3.2. Service and repair
         7.3.2.1. Work description
         7.3.2.2. Check of level of oil in the transmission
         7.3.2.3. Check and washing of the hydrokinetic transmission
         7.3.2.4. Check of pressure of oil in operational time of the transmission
         7.3.2.5. Test of an overload of the hydrokinetic transfer of motor
         7.3.2.6. Agreement of a stares of a brake of advanced planetary transfer
         7.3.2.7. Removal and installation of the regulator of vacuum
         7.3.2.8. Hydraulic auxiliary rocket of reverse planetary gear
         7.3.2.9. Centrifugal regulator of pressure of oil
         7.3.2.10. Substitution of a ring of rear fighter
         7.3.2.11. Removal and installation of the mechanism of the choice of transfers
         7.3.2.12. Removal and installation of sketch of the choice of transfers
         +7.3.2.13. Agreement of a thread of the mechanism of Kick down
         7.3.2.14. Removal and installation of the transmission
         7.3.2.15. Bad functioning of the automatic exchange
+8. Driving axle and rear bridge
+9. Direction
+10. Supports of the triangular form of interruption
+11. Brakes system
+12. Wheels and tires
+13. Body
+14. Electric equipment


bfe6b27a


7.3.2.8. Hydraulic auxiliary rocket of reverse planetary gear

GENERAL INFORMATION

Removal of the hydraulic auxiliary rocket of reverse planetary gear

1 - covering,

2 - the piston with a stick

Removal and installation

ORDER OF REALIZATION
1. To install the car on the observation channel or in the elevator.
2. To fuse the oil of the transmission.
3. To be careful withdraws a case of oil of the transmission.
4. To unscrew a covering of the hydraulic auxiliary rocket of the reverse planetary gear and to withdraw it together with the placing.
5. To take the piston of the hydraulic auxiliary rocket of the reverse planetary gear and if necessary a fighter ring will substitute.
6. To check the length of stick. The length of a stick corresponds to the distance between a face of end of a stick, adjacent to a brake of strip, and the edge of a flute below a lock ring. If necessary there will establish a stick of the necessary length.
7. The new installation is done in the sequence, the return to the removal.