FORD'S SCORPIO

1985-1994 of launch

Repair and operation of the car



Ford Skorpio
+1.1. Identification of the car
+2. Maintenance
+3. Motors
+4. System cooling
+5. Fuel system
+ 6. Union
- 7. Transmissions
   +7.1. Mechanical transmission of five speeds of type of N
   +7.2. Mechanical MT 75 transmission
   -7.3. Transmission A4LD automatic
      7.3.1. Technical characteristic
      -7.3.2. Service and repair
         7.3.2.1. Work description
         7.3.2.2. Check of level of oil in the transmission
         7.3.2.3. Check and washing of the hydrokinetic transmission
         7.3.2.4. Check of pressure of oil in operational time of the transmission
         7.3.2.5. Test of an overload of the hydrokinetic transfer of motor
         7.3.2.6. Agreement of a stares of a brake of advanced planetary transfer
         7.3.2.7. Removal and installation of the regulator of vacuum
         7.3.2.8. Hydraulic auxiliary rocket of reverse planetary gear
         7.3.2.9. Centrifugal regulator of pressure of oil
         7.3.2.10. Substitution of a ring of rear fighter
         7.3.2.11. Removal and installation of the mechanism of the choice of transfers
         7.3.2.12. Removal and installation of sketch of the choice of transfers
         +7.3.2.13. Agreement of a thread of the mechanism of Kick down
         7.3.2.14. Removal and installation of the transmission
         7.3.2.15. Bad functioning of the automatic exchange
+8. Driving axle and rear bridge
+9. Direction
+10. Supports of the triangular form of interruption
+11. Brakes system
+12. Wheels and tires
+13. Body
+14. Electric equipment


bfe6b27a


7.3.2.11. Removal and installation of the mechanism of the choice of transfers

ORDER OF REALIZATION
1. To withdraw a negative wire of the accumulator.
2. In the interior of the car to withdraw the lever of the choice of transfers, ashtray, to unscrew two screws of the fixation of a bedcover of the central consolation, to call - of captures and to withdraw a mistake.
3. To withdraw the switch of heater in a rear part of the central consolation and to unscrew two screws of the fixation of a bedcover of the consolation.
4. To withdraw a bedcover of the consolation and desconectar the capture of the easiest.
5. To unscrew two screws of the fixation of the consolation located below a compartment of cartridges and two screws in the center and an advanced part of the consolation, to withdraw the central consolation and his arm.
6. To unscrew four pins of the fixation of the mechanism of the choice of transfers.
7. To lift the mechanism of the choice of transfers, to withdraw a spring armband of the sketch of the choice of transfers and to withdraw completely the mechanism of the choice of transfers.
8. The installation is done in the sequence, the return to the removal, at the same time it is necessary to establish an advanced part of a bedcover of the consolation below the central consolation and to hold tight pins of the fixation of an arm of the consolation only after the installation of the consolation.