FORD'S SCORPIO

1985-1994 of launch

Repair and operation of the car

Ford Skorpio
+1.1. Identification of the car
+2. Maintenance
+3. Motors
+ 4. System cooling
- 5. Fuel system
   5.1. Technical characteristic
   5.2. Fuel
   5.3. Gasoline without lead of V6, 2,4 motors and 2,9 dm3
   +5.4. System of air provision
   +5.5. Carburator of PIERBURG
   -5.6. WEBER 2V carburator
      5.6.1. Turns agreement of wasting time and quality of mixture
      5.6.2. Removal and installation of the carburator
      5.6.3. Meeting and agreement of the carburator
      5.6.4. Agreement of a slit of the air door
      5.6.5. Agreement of a slit of an intermediary step
   +5.7. WEBER 2V carburator of TLD
   +5.8. System of injection of fuel
   5.9. Removal and installation of a collector of entry
+6. Union
+7. Transmissions
+8. Driving axle and rear bridge
+9. Direction
+10. Supports of the triangular form of interruption
+11. Brakes system
+12. Wheels and tires
+13. Body
+14. Electric equipment

5.6.1. Turns agreement of wasting time and quality of mixture

GENERAL INFORMATION

Screw of quality agreement of mixture of wasting time

The screw of the agreement of the quality of the mixture is shown by an arrow.

The turns agreement of wasting time is done by the module ESC II electronically.

For the agreement of the quality of the mixture it is necessary to have a tacômetro and the analyzer of the composition of gases of leak.

ORDER OF REALIZATION

1. To check a condition of the filter of air and if necessary it will substitute.

2. To heat the motor up to the work temperature.

3. Desconectar everything the consumers of the electric power.

4. To check the installation of the initial moment of the ignition.

5. There adhere to the motor a tacômetro (in the ignition off) and an analyzer of gas.

6. To increase turns of motor to 3.000 revolutions per minute and to maintain them inside 30 seconds, and soon to transfer the motor to the way that wastes time.

7. To take leituras of devices.

8. In a detour of size of contents in spite of withdrawing a protective hat of the screw of the quality of the mixture, increasing turns of motor to 3.000 revolutions per minute and maintaining them inside 30 seconds, and soon transferring the motor to the way of wasting time and, making spinning the screw of the quality of the mixture, establishing the necessary thing SO level.

Prevention

To take leituras of devices and to do the agreement it is possible only after the stabilization of indications of devices of measurement.