FORD'S SCORPIO

1985-1994 of launch

Repair and operation of the car

Ford Skorpio
+ 1.1. Identification of the car
- 2. Maintenance
   2.1. Frequency of service of cars
   2.2. Each one 10.000 km or once in a year
   2.3. Each one 40.000 km
   2.4. Each one 60.000 km or during 2 years
   2.5. Check of level of oil of motor
   2.6. Substitution of oil of motor and filter
   2.7. Places of possible hole of oil of motor and his definition
   2.8. The check of the level and substitution of cooling the liquid
   2.9. Check of tension of the system of cooling
   2.10. Taken of spark
   2.11. Substitution of the filter of air
   2.12. Substitution of the filter of fuel
   2.13. Substitution of the valve of ventilation of a case of the motor
   2.14. Liquid check in the system of air conditioning
   2.15. Check of level of oil in the transmission
   2.16. Check of level of oil in the rear bridge
   2.17. Check of a condition of a protective covering of an end of power
   2.18. The agreement of a brake carves in the automatic exchange
   2.19. Check of a condition of halls and rear shoes of brake
   2.20. Check of level and substitution of fluid of brake
   2.21. Check of a condition of a support of the triangular form of interruption
   2.22. Check of level of liquid in system of the amplifier of direction
   2.23. The cleaning of a drain of the condensed one that is formed during the operation of the condicionador
   2.24. Recommendations on motor oils
   2.25. Specifications
+3. Motors
+4. System cooling
+5. Fuel system
+6. Union
+7. Transmissions
+8. Driving axle and rear bridge
+9. Direction
+10. Supports of the triangular form of interruption
+11. Brakes system
+12. Wheels and tires
+13. Body
+14. Electric equipment

2.7. Places of possible hole of oil of motor and his definition

GENERAL INFORMATION

Places of possible hole of oil of motor:

– the porous or damaged placing of a covering of a mouth maslozalivny;
– connection of a hose of ventilation of a case with a covering of a head of the cylinder block;
– consolidation of a covering of a head of the cylinder block;
– placing of a head of the cylinder block;
– the inter-connected surface of the distributor of ignition;
– placing of rubber of a filter of oil;
– placing of the trundle bed of oil;
– consolidations of an end of inclination.

Method of definition of hole of oil of motor

ORDER OF REALIZATION

1. To check the level of oil of motor and if necessary it will add.

2. The dish does carefully the motor with the use of a cleaner of the motor.

3. The places in which is supposed what the oil hole covers of a fine layer of talcum powder or powder and executes a travel of proof in the 30 km distance.

4. To inspect the motor and to determine the place of the hole of oil for the existence of fresh stains and to withdraw the cause that led to the oil hole.