FORD'S SCORPIO

1985-1994 of launch

Repair and operation of the car

Ford Skorpio
+ 1.1. Identification of the car
- 2. Maintenance
   2.1. Frequency of service of cars
   2.2. Each one 10.000 km or once in a year
   2.3. Each one 40.000 km
   2.4. Each one 60.000 km or during 2 years
   2.5. Check of level of oil of motor
   2.6. Substitution of oil of motor and filter
   2.7. Places of possible hole of oil of motor and his definition
   2.8. The check of the level and substitution of cooling the liquid
   2.9. Check of tension of the system of cooling
   2.10. Taken of spark
   2.11. Substitution of the filter of air
   2.12. Substitution of the filter of fuel
   2.13. Substitution of the valve of ventilation of a case of the motor
   2.14. Liquid check in the system of air conditioning
   2.15. Check of level of oil in the transmission
   2.16. Check of level of oil in the rear bridge
   2.17. Check of a condition of a protective covering of an end of power
   2.18. The agreement of a brake carves in the automatic exchange
   2.19. Check of a condition of halls and rear shoes of brake
   2.20. Check of level and substitution of fluid of brake
   2.21. Check of a condition of a support of the triangular form of interruption
   2.22. Check of level of liquid in system of the amplifier of direction
   2.23. The cleaning of a drain of the condensed one that is formed during the operation of the condicionador
   2.24. Recommendations on motor oils
   2.25. Specifications
+3. Motors
+4. System cooling
+5. Fuel system
+6. Union
+7. Transmissions
+8. Driving axle and rear bridge
+9. Direction
+10. Supports of the triangular form of interruption
+11. Brakes system
+12. Wheels and tires
+13. Body
+14. Electric equipment

2.14. Liquid check in the system of air conditioning

GENERAL INFORMATION

The control happens in a temperature of motor and liquid of +18 °C to +24 °C.

ORDER OF REALIZATION

1. To withdraw a front guard.
2. To begin the motor and to secure his functioning in the only turns.
	3. To light the condicionador and 3 installs the supporter's switch (it is specified by an arrow) in a position.
4. Through the glass observation to look at a condition of liquid that during 10 seconds of the operation of the condicionador will continue without blisters. The blisters existence testifies to a lack of the liquid and low operational efficiency of a condicionador. In case of what at the same time after being lit of the bottles of condicionador of air they do not appear absolutely, it indicates to too little quantity of liquid in the system. It is necessary to put immediately the condicionador out, for an exception of the failure of the compressor and to address in the service station to be filled of the system.

The air condicionador due to the work provided that the holes could lose up to 100 g of the refrigerant liquid inside a year, therefore, is necessary to refuel the system periodicamente.