FORD'S SCORPIO

1985-1994 of launch

Repair and operation of the car

Ford Skorpio
+1.1. Identification of the car
+2. Maintenance
+3. Motors
+4. System cooling
+5. Fuel system
+6. Union
+7. Transmissions
+8. Driving axle and rear bridge
+9. Direction
+ 10. Supports of the triangular form of interruption
- 11. Brakes system
   11.1. Technical characteristic
   +11.2. Dispatch brakes
   +11.3. Subsequent brakes
   11.4. Agreement of the brake of emergence
   11.5. Removal of air of the system of brakes
   -11.6. System antiblockade
      11.6.1. Check that works
      11.6.2. Removal and installation of hydraulic knot of management
      11.6.3. Removal and installation of a pedal of brake
      11.6.4. Removal and installation of the accumulator of hydraulic knot
      11.6.5. Removal and installation of the bomb and motor of hydraulic knot
      11.6.6. Substitution of the sensor of speed of rotation of an advanced wheel
      11.6.7. Substitution of the sensor of speed of rotation of a rear wheel
+12. Wheels and tires
+13. Body
+14. Electric equipment

11.6.7. Substitution of the sensor of speed of rotation of a rear wheel

GENERAL INFORMATION

Prevention

The brake fluid is in an outline of rear brakes below the high pressure. It is not necessary to hold tight a pedal of brake.

Removal

ORDER OF REALIZATION

1. To weaken nuts of the fixation of the corresponding rear wheel.
2. To lift the car and to withdraw a wheel.
3. To launch the lever of the brake of emergence.
4. To lift behind the session and to reject a covering of the floor ahead.
	5. To take a wire of a support of triangular form and desconectar the electric capture (it is specified by an arrow) of the sensor of the speed of the rotation of a wheel.
6. Desconectar a thread of the brake of emergence of a support of triangular form in the lever of a rear support of the triangular form of interruption.
7. To take an advanced pin of the fixation of a support of brake.
8. To raise a support.
9. To unscrew a pin of the fixation of the sensor and to take it.

Installation

ORDER OF REALIZATION

1. To compensate for a nest to fixation of the sensor of the speed of the rotation of a wheel of the dirt, rust aspects, etc.

2. To polish lightly a nest of the fixation of the sensor with the loads lubricant.

3. To install a new ring of fighter of the round section in the sensor.

4. To execute the same initial operations that give themselves during the installation of the sensor of the speed of the rotation of a wheel advanced in the subsection 11.6.6, and soon to execute the operations happened in the moment of the removal of the sensor of the speed of the rotation of a rear wheel in the sequence of return.