Ford Skorpio
+1.1. Identification of the car
+2. Maintenance
+3. Motors
+4. System cooling
+5. Fuel system
+6. Union
+7. Transmissions
+8. Driving axle and rear bridge
+9. Direction
+ 10. Supports of the triangular form of interruption
- 11. Brakes system
11.1. Technical characteristic
+11.2. Dispatch brakes
+11.3. Subsequent brakes
11.4. Agreement of the brake of emergence
11.5. Removal of air of the system of brakes
+11.6. System antiblockade
+12. Wheels and tires
+13. Body
+14. Electric equipment
|
The air removal executes always after confiding of hydraulic brakes outlines, and also when the pedal of a brake is "gentle" and there are necessary several times hold tight it that the brakes began to work.
It is impossible to unscrew deaerators of rear brakes when the hydraulic accumulator is below the pressure and also if the pedal of a brake corsets itself. The hydraulic brake feeds an outline of rear brakes below the pressure of 18 MPas.
Before the realization of any action that can result from an effluence of fluid of brake there are necessary 20 times lower certainly the pressure in the accumulator for the strong pressing approximately in a brake pedal.
In service, agreement and brakes repair is impossible to include the ignition if it is not demanded by the education of the service.
It is necessary to use the fluid of brake recommended by the firm manufacturer of the car and to empty it of the original, capacities only open.
During the removal of air of brakes there is necessary to support all the time the necessary level of fluid of brake in a tank.
Removal of air of an outline of advanced brakes
| ORDER OF REALIZATION |
| 1. There puts the deaerator of an advanced brake a transparent tube of the artificial material. To lower another end of a tube in the transparent capacity was filled of the brake fluid. |
| 2. To hold tight a pedal of brake. If the resistance is not shown, then is necessary to hold tight it until it begins to show the considerable resistance. |
| 3. In the compressed pedal of a brake to weaken the deaerator. To maintain a pedal all the time, the bottles rise of air are visible for the time being. |
| 4. To crush the deaerator and to launch a pedal of brake. |
| 5. To repeat two last operations until the brake fluid without air bottles does not begin to follow of a tube. |
| 6. Of the same way withdraws the air of an outline of the second advanced brake. |
|
Removal of air of an outline of rear brakes
| ORDER OF REALIZATION |
|
1. To put the deaerator of a few back they curb a transparent tube (it is specified by an arrow) of the artificial material. To lower another end of a tube in the transparent capacity was filled of the brake fluid. |
| 2. To hold tight a pedal of brake. |
| 3. To weaken the deaerator. |
| 4. To include the ignition. It will put the hydraulic bomb in the action and will curb the fluid will begin to follow of a tube. It is necessary to wait until the next liquid contains bottles of air. |
| 5. To launch a pedal of a brake and to crush the deaerator. |
| 6. To put the ignition out and to wait, the hydraulic bomb still will not stop. |
| 7. To repeat these actions of the removal of air of an outline of the second rear brake. |
|
|
|
