FORD'S SCORPIO

1985-1994 of launch

Repair and operation of the car

Ford Skorpio
+1.1. Identification of the car
+2. Maintenance
+3. Motors
+4. System cooling
+5. Fuel system
+6. Union
+7. Transmissions
+8. Driving axle and rear bridge
+9. Direction
+ 10. Supports of the triangular form of interruption
- 11. Brakes system
   11.1. Technical characteristic
   +11.2. Dispatch brakes
   +11.3. Subsequent brakes
   11.4. Agreement of the brake of emergence
   11.5. Removal of air of the system of brakes
   -11.6. System antiblockade
      11.6.1. Check that works
      11.6.2. Removal and installation of hydraulic knot of management
      11.6.3. Removal and installation of a pedal of brake
      11.6.4. Removal and installation of the accumulator of hydraulic knot
      11.6.5. Removal and installation of the bomb and motor of hydraulic knot
      11.6.6. Substitution of the sensor of speed of rotation of an advanced wheel
      11.6.7. Substitution of the sensor of speed of rotation of a rear wheel
+12. Wheels and tires
+13. Body
+14. Electric equipment

11.6.5. Removal and installation of the bomb and motor of hydraulic knot

ORDER OF REALIZATION

1. To withdraw a negative wire of the accumulator.
2. Desconectar a hose of the high pressure of the bomb.
3. Desconectar a hose of the low pressure of the bomb and to fuse the fluid of brake for him.
4. To withdraw taken of multiproduction of the sensor of the pressure and the motor of the bomb.
	5. The fastenings of the bomb unscrew a pin (it is specified by an arrow).
6. To separate the bomb with the electric motor of the capture of the installation and to withdraw them.
7. To withdraw taken of the installation and to substitute them if necessary.
8. During the installation of the new bomb to install in him the sensor of pressure with a new ring of fighter of the round section.
9. To install the bomb in captures of the installation and to join a hose of the low pressure.
10. To fix the bomb for a pin.
11. To join a hose of the high pressure with the new fighter placing.
12. To install the accumulator of the hydraulic knot with new rings of fighter of the round section.
13. To adhere taken of multiproduction to the sensor of the pressure and the motor of the bomb.
14. To fill out the fluid of brake in the tank, to include the ignition and to give the possibility to the bomb to be filled of the brake fluid.
Prevention The bomb will work not more than two minutes.