FORD'S SCORPIO

1985-1994 of launch

Repair and operation of the car

Ford Skorpio
+1.1. Identification of the car
+2. Maintenance
+3. Motors
+4. System cooling
+5. Fuel system
+6. Union
+7. Transmissions
+8. Driving axle and rear bridge
+9. Direction
+10. Supports of the triangular form of interruption
+11. Brakes system
+12. Wheels and tires
+ 13. Body
- 14. Electric equipment
   14.1. Technical characteristic
   14.2. Locks of security and alternation
   14.3. Unities of electronic control
   14.4. System of the central blockade
   14.5. System of rates of turns
   14.6. Fuel computer
   14.7. System of additional control
   -14.8. Creator
      14.8.1. Removal and installation of the creator
      14.8.2. To be demolished and meeting of the creator
      14.8.3. Substitution of brushes of the creator and regulator of tension
      14.8.4. Bad main functioning of the creator
      14.8.5. Agreement of a tension of a belt of side
   +14.9. Author
   +14:10. I bread to rub of fabric Windshield, knot of rates and lighthouse
   14:11. Removal and installation of a combination of devices
   14:12. Extern and internal lighting
   +14:13. Another electric equipment
   +14:14. Electric printers

14.8.4. Bad main functioning of the creator

GENERAL INFORMATION

Checking the creator, and also in the moment of the operation of the car it is necessary to follow a number of simple rules of the creator not to damage:

  – not to allow the operation of the creator with the battery recarregável off;
  – not to check the operation of the creator "of the spark" as at the same time he was seeing diodes considerable current product, and they fail;
  – not to check diodes any more than 12 V or the meter megohm;
  – when it executes electrowelding it works for desconectar all the wires of the creator and of the battery recarregável;
  – to check knots and chains of the electric equipment and to remove bad functioning in the idle motor and the battery recarregável off.

REASON	METHOD OF ELIMINATION
In the moment of the inclusion of the ignition the lamp of control of the accumulator which snake does not burn itself
Interval of a wire between the creator, the lock of ignition and a lamp of control	To check the tension in a chain, which begins with the creator
The accumulator is unloaded	To check the tension and, if necessarily, to collect the accumulator
The bulb merged	If it is confirmed, to substitute a bulb
The creator brushes badly prohibited they is next to contact with rings	To check the length of brushes and the freedom of his movement in the bearer
The curve of excitement of the creator is set alight	To check a rotor and diodes that in the moment of the detection of defects are subject to the substitution
The lamp of control of the accumulator which snake does not go out slowly in the increase in turns of the motor
The tension regulator failed	To substitute with the new
The wire between the creator and a control lamp has the contact with the weight	To substitute a braid of wires or besides that to isolate a wire
The lamp of control of the load of accumulator is burned in the ignition off
Short circuit of the diode	To check diodes and defective to substitute