FORD'S SCORPIO

1985-1994 of launch

Repair and operation of the car

Ford Skorpio
+1.1. Identification of the car
+2. Maintenance
+3. Motors
+4. System cooling
+5. Fuel system
+6. Union
+7. Transmissions
+8. Driving axle and rear bridge
+9. Direction
+10. Supports of the triangular form of interruption
+11. Brakes system
+12. Wheels and tires
+ 13. Body
- 14. Electric equipment
   14.1. Technical characteristic
   14.2. Locks of security and alternation
   14.3. Unities of electronic control
   14.4. System of the central blockade
   14.5. System of rates of turns
   14.6. Fuel computer
   14.7. System of additional control
   -14.8. Creator
      14.8.1. Removal and installation of the creator
      14.8.2. To be demolished and meeting of the creator
      14.8.3. Substitution of brushes of the creator and regulator of tension
      14.8.4. Bad main functioning of the creator
      14.8.5. Agreement of a tension of a belt of side
   +14.9. Author
   +14:10. I bread to rub of fabric Windshield, knot of rates and lighthouse
   14:11. Removal and installation of a combination of devices
   14:12. Extern and internal lighting
   +14:13. Another electric equipment
   +14:14. Electric printers

14.8.2. To be demolished and meeting of the creator

GENERAL INFORMATION

Creator of Bosch

1 pulley of the supporter,
2 - dispatch the covering,
3 - rotor,
4 - load,
5 - fixed part of the electric motor,

6 - rectifier,
7 - rear cape,
8 - the bearer brushes,
9 - electronic regulator
tension

Lucas's creator

1 pulley of the supporter,
2 - dispatch the covering,
3 - rotor,
4 - load,
5 - fixed part of the electric motor,

6 - rectifier,
7 - rear cape,
8 - the bearer brushes,
9 - electronic regulator
tension

Creator of Motorola

1 pulley of the supporter,
2 - dispatch the covering,
3 - rotor,
4 - load,
5 - fixed part of the electric motor,

6 - rectifier,
7 - rear cape,
8 - the bearer brushes,
9 - electronic regulator
tension

In the course of the repair of the creator it is necessary to join to the next educations:

  – the diodes put in the creator are sensitive to the high temperature; in case of the necessity his substitutions in the course of the solder must maintain his conclusions with metal tweezers that take the heat of a prick from iron of solder, and also limit the time from solder by a necessary minimum;

  – it is necessary to avoid the use of ferros of solder electric unfounded as in case of the damage of his isolation that they will cause to the diodes exhaustion vypryamitelny of the creator;

  – in the course of tests of control of the creator of the provision the voltage must not exceed 14B;

  – in the course of the diodes check vypryamitelny it is possible to use a tension of continuous current, without exceeding 24 V;

  – to clean of details it is necessary only to use to gasoline; at the same time after cleaning of details (specially windings) is necessary to drain them a current of compressed air.