FORD'S SCORPIO

1985-1994 of launch

Repair and operation of the car

Ford Skorpio
+1.1. Identification of the car
+2. Maintenance
+3. Motors
+4. System cooling
+5. Fuel system
+6. Union
+7. Transmissions
+8. Driving axle and rear bridge
+9. Direction
+10. Supports of the triangular form of interruption
+11. Brakes system
+12. Wheels and tires
+ 13. Body
- 14. Electric equipment
   14.1. Technical characteristic
   14.2. Locks of security and alternation
   14.3. Unities of electronic control
   14.4. System of the central blockade
   14.5. System of rates of turns
   14.6. Fuel computer
   14.7. System of additional control
   -14.8. Creator
      14.8.1. Removal and installation of the creator
      14.8.2. To be demolished and meeting of the creator
      14.8.3. Substitution of brushes of the creator and regulator of tension
      14.8.4. Bad main functioning of the creator
      14.8.5. Agreement of a tension of a belt of side
   +14.9. Author
   +14:10. I bread to rub of fabric Windshield, knot of rates and lighthouse
   14:11. Removal and installation of a combination of devices
   14:12. Extern and internal lighting
   +14:13. Another electric equipment
   +14:14. Electric printers

14.8.1. Removal and installation of the creator

GENERAL INFORMATION

Fixation of the creator in two pins

1 - a boy lavador (it can be going away),

2 - arm of fixation of the creator,
3 - creator,

4 - great lavador

Removal

ORDER OF REALIZATION

1. For desconectar they connect a weight of the accumulator, and also the capture of the connection of multicontact behind the creator (after the removal of a fastener of security).
Prevention At the same time the information in electronic memory devices goes out of the memory.
2. To weaken pins of the fixation of the creator.
3. To turn the creator to the motor and there takes away the side a belt of a creator's pulley.
	4. To unscrew pins of the fixation and to take the creator (1 – wires connection, 2 – the lowest pins of the fixation).

Installation

ORDER OF REALIZATION

1. To insert the creator, to crush pins of his fixation and them to shake hands.
2. To join and to fix the capture of the connection of multicontact of wires behind the creator.
	3. To establish and there pulls the side a belt (1 – pin of the device of tension, And = 10 mm – a deflexão of belt).
	4. To hold tight a pin of the agreement of a tension, then an advanced pin (the firearm) of the lowest fixation and, finally, a rear pin (the firearm) of the lowest fixation of the creator.
5. To join a weight they connect to the accumulator.
6. To check a tension of a belt of side.
7. In case of the necessity of weakening pins of the fixation of the creator, a belt to pull the side and again of holding tight pins, from a pin of the agreement of a tension, and soon a pin of the advanced one and the rear fixation of the creator.