FORD'S SCORPIO

1985-1994 of launch

Repair and operation of the car

Ford Skorpio
+1.1. Identification of the car
+2. Maintenance
+3. Motors
+4. System cooling
+5. Fuel system
+6. Union
+ 7. Transmissions
- 8. Driving axle and rear bridge
   8.1. Technical characteristic
   +8.2. Driving axle
   -8.3. Zadny Bridge
      8.3.1. Removal and installation of the rear bridge
      8.3.2. To be demolished and meeting of the rear bridge
      8.3.3. Differential Desmontagem
      8.3.4. Differential meeting
      8.3.5. Agreement of loads of wheels of gear of the main transfer
      8.3.6. Agreement of wheels of gear of the main transfer
      8.3.7. Meeting and agreement of the main transfer
      8.3.8. Substitution of a ring of fighter of a wheel of gear of the main transfer
   +8.4. Power ends
+9. Direction
+10. Supports of the triangular form of interruption
+11. Brakes system
+12. Wheels and tires
+13. Body
+14. Electric equipment

8.3.7. Meeting and agreement of the main transfer

GENERAL INFORMATION

Measurement of a slit of the main transfer

ORDER OF REALIZATION

1. To install loads in a differential box, observing an ancient agreement of the elements they interact.

2. To establish new placing of the round section, and also new rings of fighter (adaptation 15.076) in a flange of the agreement of a slit of loads.

3. To loads of oil of a box of differential of the same type, as for the rear bridge.

4. To establish differential, and also flanges of the agreement of a slit of loads and to crush them a hand so that the loads were made at the place.

5. After the realization (the hand) of several turns of ten for a wheel of gear of the main transfer (to put of conical loads of a box of the differential one) the wheels of gear of the main transfer they have to adjust so that the slit was not felt almost.

6. To establish the bearer of indicative of hour they type in a differential box, and to rest his tip of measuring in the right angle against one of teeths of the wheel of driven gear of the main transfer.

7. To hold tight a flange of the agreement of a slit of the load of a box of differential of the wheel of driven gear of the main transfer and to weaken the flange of the agreement of a slit of the load located in the opposite side so that it receives a slit mezhzubyevy of the main transfer of 0,01 equal mm.

8. To crush a flange of the agreement of a slit of the load of the differential one in 4-5 teeths.

9. To spin repeatedly a wheel of gear of the main transfer and to measure mezhzubyevy a slit at three places of the wheel of driven gear of the main transfer (approximately everyone 120 °).

10. To establish armbands (of unscrewing) the flanges of the agreement of a slit of loads.

11. To establish a covering of a case of the back they launch one work as a prompter together with the new placing, and also the plate with identification data.

QX4.ONLINE
S40.ONLINE
A-8.ONLINE
W124.ONLINE
RX300.ONLINE
W140.ONLINE
B3-B4.SPACE
B3B4.SPACE
A-8.SPACE