Ford Skorpio
+1.1. Identification of the car
+2. Maintenance
+3. Motors
+4. System cooling
+5. Fuel system
+6. Union
+ 7. Transmissions
- 8. Driving axle and rear bridge
8.1. Technical characteristic
-8.2. Driving axle
8.2.1. Removal and installation
8.2.2. Repair of the intermediary load
+8.3. Zadny Bridge
+8.4. Power ends
+9. Direction
+10. Supports of the triangular form of interruption
+11. Brakes system
+12. Wheels and tires
+13. Body
+14. Electric equipment
|
Union of rubber of the driving axle GAF 30
|
|
1 - metal union,
2 - rubber dampers,
3 - rubber covering |
Union of rubber of the driving axle GAF 41
|
|
1 - nuts of connection of the union with a damper,
2 - Union of GAF,
3 - damper,
4 - union of end of nuts of connection |
Removal of the intermediary load
1 - lock the ring,
2 - I set pins,
3 - intermediary load, |
4 - case of the intermediary load,
5 - transversalmente hinge,
6 - agreement plates of U-shaped |
Removal of the intermediary load through an artist of streaptise
| ORDER OF REALIZATION |
| 1. To install the car on the observation channel or in the elevator. |
|
2. To indicate the flexible mutual position of the transversalmente and a flange of a wheel of gear of the main transfer and desconectar the driving axle of the rear bridge (the pins of the fixation of a rear flange are specified by firearms). To unscrew the case of the intermediary load, having indicated to provision of the placing between the case of the load and a hoof of the car (these designations will be useful during the installation of the driving axle and his intermediary's load). |
| 3. Desconectar the driving axle of the transmission, installment of attention not to damage a ring of fighter in a rear part of a case. After the extraction of an end the opening in a rear part of a case of the transmission must deaden a cork or an advanced tip of the defective driving axle not to allow an effluence of oil of the transmission. |
|
Installation
| ORDER OF REALIZATION |
| 1. Of an opening of a rear part of a case of the transmission to take a cork. To check the installation of a ring of fighter of a rear part of a case of the transmission and to insert in him the advanced end of the driving axle, installment of attention not to damage an edge of a ring of fighter. |
| 2. To install the intermediary load of the driving axle, having arranged below him the corresponding placing according to the designations put during the desmontagem (without holding tight pins of fixation). |
| 3. The driving axle adheres to a flange of the wheel of main gear of the main transfer according to the designations of a posicionamento of relative put before. To establish the new protection of placing fires of unscrewing. |
| 4. The rotation of the driving axle to install the intermediary load and to hold tight the fixation fires on the corresponding moment. |
| 5. To check and in case of the necessity of adding the amount of oil in the transmission. |
|
MT 75 TRANSMISSION
The difference of the driving axle used with the MT 75 transmission is composed in the fixation of the driving axle to the transmission.
| ORDER OF REALIZATION |
| To unscrew three nuts of the fixation of the union of rubber of the driving axle to an end of production of the transmission and to withdraw the driving axle. 41 devote themselves two types of GAF 30 of rubber or union GAF. |
|
UNION GAF 30
The hair clips of hair of the fixation of the union must not be turned in the appendix of the moment of 80 nanômetros. In case of what the hair hair clip be turning in the appendix of the least moment, has to be unscrewed and to be established as one follows.
| ORDER OF REALIZATION |
| 1. To compensate for a woodcarving in a transmission flange. |
| 2. Way of low two to apply in an openings woodcarving against unscrewing (of two parties of an opening), to crush immediately a hair clip of hair and inside 30 minutes to give to ways the possibility to be hardened. |
| 3. To check a condition of the union of rubber of the existence of mechanical damages and slits. In the presence of slits the driving axle is subject to the substitution like the driving axle it is balanced with the union like the only total. Substituting the driving axle in order that 41 establishing an end with the union GAF. |
| 4. To fix the union to the transmission, using new nuts. |
|
UNION GAF 41
Unscrewing, check and they do installation in the same way, as for the union GAF 30 unless the hair hair clips must not be turned in the appendix of the moment of 110 nanômetros. |
|
