FORD'S SCORPIO

1985-1994 of launch

Repair and operation of the car

Ford Skorpio
+1.1. Identification of the car
+2. Maintenance
+3. Motors
+4. System cooling
+5. Fuel system
+6. Union
+ 7. Transmissions
- 8. Driving axle and rear bridge
   8.1. Technical characteristic
   +8.2. Driving axle
   -8.3. Zadny Bridge
      8.3.1. Removal and installation of the rear bridge
      8.3.2. To be demolished and meeting of the rear bridge
      8.3.3. Differential Desmontagem
      8.3.4. Differential meeting
      8.3.5. Agreement of loads of wheels of gear of the main transfer
      8.3.6. Agreement of wheels of gear of the main transfer
      8.3.7. Meeting and agreement of the main transfer
      8.3.8. Substitution of a ring of fighter of a wheel of gear of the main transfer
   +8.4. Power ends
+9. Direction
+10. Supports of the triangular form of interruption
+11. Brakes system
+12. Wheels and tires
+13. Body
+14. Electric equipment

8.3.5. Agreement of loads of wheels of gear of the main transfer

ORDER OF REALIZATION

1. Through devices 15.033 and 15.074 to take an extern ring of the extern load of a wheel of gear of the main transfer of a case of the rear bridge.

2. 15.033 establishes a new extern ring of the extern load of a wheel of gear of the main transfer through the adaptation.

3. To take in the same way an extern ring of the internal load.

4. 15.083 establishes a new extern ring of the internal load together with the new placing of 2 mm of thickness through the adaptation.

5. Through the artist of streaptise correspondent to withdraw the internal conical load (an internal ring and rolls) of a wheel of gear of the main transfer and to withdraw the remote capture.

6. To install the new internal conical load together with the new placing of 1 mm of thickness located between the load and a wheel of gear of the main transfer.

7. To conical loads of oil of a wheel of gear of transmissions.

8. To insert a wheel of gear in a case, to install the remote capture and the extern conical connection with a gear wheel.

9. To put the armband of the fixation of loads and to hold tight it through a bent key of 36 mm hat and adaptation 15.073. During the pressure of a nut through the dynamometer 15,041 put ones in the adaptation 15.073 is necessary to measure the moment of the resistance of the rotation of a wheel of gear of the main transfer. The nut of the fixation of loads must corset itself so that it carries out the necessary moment of the resistance of the turn of a wheel of gear.