FORD'S SCORPIO

1985-1994 of launch

Repair and operation of the car

Ford Skorpio
+1.1. Identification of the car
+2. Maintenance
+3. Motors
+4. System cooling
+ 5. Fuel system
- 6. Union
   6.1. Technical characteristic
   -6.2. Service and repair
      6.2.1. Union removal
      6.2.2. Union check
      6.2.3. Union installation
      6.2.4. Substitution of the load of needle of an end of union
      6.2.5. Substitution of a thread of union
      6.2.6. Mechanism of pedal of union
      6.2.7. Substitution of a pedal of union
      6.2.8. Removal and installation of the load of launch
      6.2.9. Agreement of releases to go round
+7. Transmissions
+8. Driving axle and rear bridge
+9. Direction
+10. Supports of the triangular form of interruption
+11. Brakes system
+12. Wheels and tires
+13. Body
+14. Electric equipment

6.2.6. Mechanism of pedal of union

GENERAL INFORMATION

Union pedal

1 - I crunch,

2 - spring,

3 - axle and armband of a latch,

4 - taken,

5 - union pedal,

6 - spring of a tension of the sector of gear,

7 - gear sector

The armband of the automatic mechanism can be blockaded in the sector of gear of a pedal of the union, specially with the considerable use. There will not be free one to go round of a thread in this case that will lead to the in favor sliding of the union and considerably it will accelerate the use of mistakes. For the check of the mechanism it is necessary to open a monk's hood and to spread out agudamente a covering of end of a splitting that will lead to a tension of a thread and the turn of a segment of gear. During the normal operation of the clicks of mechanism of the latch that removes a segment of gear they are heard and in an end covering otpuskaniye the mechanism maintains an initial position. In case of the interference of a latch it is impossible to spread out a covering of end of a splitting.

There was an interference, to withdraw a thread of the union is problematic.

First option of removal of a thread: to make an effort of the commutation - of the lever of a lack of interest of end.

The second – to cut a thread, nevertheless it is necessary to be remembered that the commutation - of the lever at the same time will return.

The thread that it pulls of a splitting advanced sometimes is taken by it to the elimination that sticks, nevertheless it is desirable to substitute the mechanism with the new in this case.