FORD'S SCORPIO

1985-1994 of launch

Repair and operation of the car

Ford Skorpio
+1.1. Identification of the car
+2. Maintenance
+3. Motors
+4. System cooling
+ 5. Fuel system
- 6. Union
   6.1. Technical characteristic
   -6.2. Service and repair
      6.2.1. Union removal
      6.2.2. Union check
      6.2.3. Union installation
      6.2.4. Substitution of the load of needle of an end of union
      6.2.5. Substitution of a thread of union
      6.2.6. Mechanism of pedal of union
      6.2.7. Substitution of a pedal of union
      6.2.8. Removal and installation of the load of launch
      6.2.9. Agreement of releases to go round
+7. Transmissions
+8. Driving axle and rear bridge
+9. Direction
+10. Supports of the triangular form of interruption
+11. Brakes system
+12. Wheels and tires
+13. Body
+14. Electric equipment

6.2.5. Substitution of a thread of union

GENERAL INFORMATION

Lack of interest of thread Coupling of a pedal of union

1 - union thread,

2 - gear sector

Removal

ORDER OF REALIZATION

1. To install the car on an observation hole or to lift it in the elevator.
2. To withdraw a covering of forks of the extinguishment of the union of a case of union after the removal of a spring hook.
3. To withdraw a cork of catraca of the gear sector, having enclosed the grindstone from corresponding wood below an union pedal.
	4. Desconectar the end of a thread of the union that puts forks out, lowering his end, and soon to dispatch.
5. To withdraw the left part of a few articles of tapestry on pedals.
6. To unhook a thread of a pedal with the gear sector and to move it through an opening between a pedal and the sector of gear.
7. To spread a thread out through an opening of a splitting advanced in a driving compartment.

Installation

ORDER OF REALIZATION

1. To insert a thread through an opening in an advanced splitting of a driving compartment, to execute it between a pedal of the union and the sector of gear and to hook up to his end in this sector.

2. To pull a thread ahead to spread it out of a covering and to hook up to another end of his in the union that puts forks out.

3. To fix a rubber that fits together with a spring hook in a case of union.

4. To extract the wooden grindstone of bass of a pedal of union.

5. To establish at the place before withdrew articles of tapestry on pedals.

6. To lower the car.