FORD'S SCORPIO

1985-1994 of launch

Repair and operation of the car

Ford Skorpio
+1.1. Identification of the car
+2. Maintenance
+ 3. Motors
- 4. System cooling
   4.1. Technical characteristic
   +4.2. Unloading of liquid and stuffing of the system of cooling
   4.3. Removal and installation of an electric heater
   4.4. Removal and installation of the thermostat
   -4.5. Supporter
      4.5.1. Removal and installation of the supporter with the hydraulic union
      4.5.2. Removal and installation of the supporter with the electric walk
   4.6. Cooling of bomb of system
   4.7. Temperature sensor
   4.8. Driving of belt of the motor DOHC
   4.9. Mechanism of a tension of a belt of driving
+5. Fuel system
+6. Union
+7. Transmissions
+8. Driving axle and rear bridge
+9. Direction
+10. Supports of the triangular form of interruption
+11. Brakes system
+12. Wheels and tires
+13. Body
+14. Electric equipment

4.5. Supporter

4.5.1. Removal and installation of the supporter with the hydraulic union

GENERAL INFORMATION

Supporter of electric heater of motor of OHC

1 - hydraulic union of the supporter,

2 - supporter's blades,

3 - creator,

4 - I belt,

5 - supporter's pulley,

6 - pulley of an end of inclination

Key to unscrew of the union of the supporter

Sizes: H=25mm, Y=12mm.

Hydraulic union of the supporter

1, 2, 3 – an advanced part of the case,
4 - spring bimetálica,
5 - with edges they cool the case,
6 - valve,

7 - entry opening,
8 - consolidation,
9 - rotor,
10 - power end

ORDER OF REALIZATION

1. For desconectar they connect a weight of the accumulator.
2. To withdraw the superior part of a covering of the supporter, having unscrewed two pins and having desconectado four clips.
	3. To unscrew the supporter's union of a nave of the bomb of cooling the liquid. The key rozhkovy bent of s=32 (OHC) or s=36mm (V6) it is necessary to unscrew.
Prevention The nut of the fixation of the union of the supporter has the left woodcarving.
4. Unscrewing a nut of the union of the supporter in order that a belt holding tight the side and so to prevent a nave of a provorachivaniye.
	5. To unscrew 4 pins and to withdraw a krylchatka of the union.
6. The installation is done in the sequence of the return to the removal.